Toyota Tundra. Manual — part 2295
Fig. 41: Locating Ignition Coil, VVT Sensor And Noise Filter Connectors (RH)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
c
Disconnect the 2 clamps and power steering oil pressure switch connector
Fig. 42: Locating Clamp And Junction Connector
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
d
Disconnect the clamp and junction connector
9
REMOVE INTAKE MANIFOLD
a
Remove the intake manifold (See REMOVAL )
10
DISCONNECT AIR PUMP HOSE AND WIRE HARNESS
a
Disconnect the No 2 and No 3 air hoses
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Fig. 43: Locating Clamps With No. 2 And No. 3 Air Pump Hoses
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Disconnect the 2 clamps
11
DISCONNECT HEATER HOSE AND PIPE
a
Remove the 2 bolts and disconnect the 3 hoses
Fig. 44: Locating Heater Hoses And Mounting Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
12
DISCONNECT COOLER COMPRESSOR ASSEMBLY
a
Remove the 2 bolts, 2 nuts and 2 stud bolts, and disconnect the cooler compressor
HINT:
It is not necessary to completely remove the compressor With the hoses connected to the
compressor, hang the compressor on the vehicle body with a rope
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Fig. 45: Identifying Cooler Compressor Bolt And Nuts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
13
DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY
a
Remove the 2 bolts and disconnect the fuel tube
Fig. 46: Locating No. 2 Fuel Tube Sub-Assembly Bolts
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
14
REMOVE OIL FILTER ELEMENT (See REPLACEMENT )
15
REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY (See REMOVAL )
16
REMOVE NO. 2 WATER BY-PASS PIPE (w/ Oil Cooler)
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Fig. 47: Locating No. 2 Water By-Pass Hoses And Bolts (W/ Oil Cooler)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
a
Remove the 3 bolts
b
Disconnect the 4 hoses and remove the water bypass pipe
17
REMOVE NO. 1 OIL COOLER BRACKET (w/ Oil Cooler) (See REMOVAL )
18
REMOVE OIL FILTER BRACKET (w/ Oil Cooler) (See REMOVAL )
19
REMOVE OIL FILTER BRACKET (w/o Oil Cooler)
a
Remove the 2 bolts, 2 nuts and oil filter bracket
Fig. 48: Locating Oil Filter Bracket Bolts And Nuts (W/O Oil Cooler)
Courtesy of TOYOTA MOTOR SALES, U.S.A., INC.
b
Remove the 2 O-rings
2009 Toyota Tundra
2009 ENGINE Lubrication (3UR-FBE) - Tundra
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст