Kia Carnival (2007 year). Manual — part 151

7. Remove the split pin and lower arm bolts and nut (A).

Tightening torque Nm (kgf-m, lb-ft):
90 ~ 120 (9.0 ~ 12.0, 65 ~ 87)

8. Disconnect the stabilizer link (B) from the strut assembly (A) by loosening nut.

Tightening torque Nm (kgf.m, lb-ft):
100 ~ 120 (10.0 ~ 12.0, 72 ~ 87)

9. Repeat on the other side.

10. Remove the front and rear roll stopper bolts and nuts (A, B).

11. Remove the sub-frame by loosening the bolts and nuts.

12. Remove the rear roll stopper (A) from the sub-frame.

13. Disconnect the pressure tube (A) and return (B) from the valve body housing.

Tightening torque Nm (kgf.m, lb-ft):
12 ~ 18 (1.2 ~ 1.8, 9 ~ 13)

14. Remove the power steering gear box (A) from the sub-frame by loosening the mounting bolts.

Tightening torque Nm (kgf.m, lb-ft):
60 ~ 80 (6.0 ~ 8.0, 43~58)

INSTALLATION

Be sure to connect between a tube and a hose as shown in the illustration.

1. Installation is the reverse of removal.

2. After installation, bleed the power steering system. (Refer to the air bleeding in ST group)

3. Adjust the wheel alignment. (Refer to SS group)

DISASSEMBLY

1. Remove the tie rod end (B) from the tie rod (A).

2. Remove the dust cover (B) from the ball joint (A).

3. Remove the bellows band (A).

4. Remove the bellows clip (A).

5. Pull the bellows out toward the tie rod.