Kia Carnival (2007 year). Manual — part 464
5. Press the clutch pedal to the seat ground.
6. Adjust the ignition lock switch position with the pedal a little(23~26mm) raised.
7. Install the ignition lock switch firmly.
TORQUE:
8~10Nm (80~100kgf.cm, 5.8~7.2lb-ft)
REPLACEMENT
a. Inspect the continuity of the ignition lock switch.
b. Remove the floor mat before adjusting the clutch pedal.
1. Remove the ignition lock switch.
2. Remove the snap pin and the clevis pin(A) connecting the clutch master cylinder push rod and the clutch pedal.
3. Remove the clutch master cylinder mounting nut(A,B) and the clutch pedal mounting nut(C).
4. Remove the clutch pedal.
5. Install a new one by tightening the bolts of the clutch pedal bracket and master cylinder .
TORQUE :
19~26 Nm(19~260 kgf.cm, 13.8~18.9 Ib-ft)(Clutch pedal bracket)
12~16 Nm(120~160 kgf.cm, 8.7~11.6 Ib-ft)(Clutch master cylinder)
6. Grease the clevis pin and insert it and the snap pin.
7. Adjust the clutch pedal and the ignition lock switch.
CHAPTER 2:
J2.9L DIESEL CRDI(VGT)
Engine Mechanical System
2007 > J2.9L DIESEL CRDI(VGT) >
SPECIAL SERVICE TOOLS
Tool (Number and name)
Illustration
Use
Valve spring lifter pivot.
(0K993 120 004)
Removal or installation of the valve spring
Valve spring lifter arm.
(0K993 120 001)
Removal or installation of the valve spring
Valve seal installer.
(09222-22001)
Installation of the valve seal
Camshaft pulley holder.
(09231 - 4X100)
Installation of the camshaft
Pressure gauge adapter.
(0K552 131 002)
Measurement of compression pressure
End york holder.
(09517-21700)
Removal or installation of the crankshaft
pulley bolt
(used with 09231-H1000)
Crankshaft pulley adapter.
Removal or installation of the crankshaft
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст