Kia Carnival (2007 year). Manual — part 53
Purge Control Solenoid
Valve
(PCSV)
![](/vehicles/jado/eand/bondeakie/jes.png)
2007 > 2.7L V6 GASOLINE >
INSPECTION
When disconnecting the vacuum hose, make an identification mark on it so that it can be reconnected to its
original position.
1. Disconnect the vacuum hose from the solenoid valve.
2. Detach the harness connector.
3. Connect a vacuum pump to the nipple which is connected to intake manifold.
4. Apply vacuum and check when voltage is applied to the PCSV and when the voltage is discontinued.
Battery voltage
Normal condition
When applied
Vacuum is released
When discontinued
Vacuum is maintained
5. Measure the resistance between the terminals of the solenoid valve.
PCSV coil resistance(
Ω) :
14.0 ~ 18.0
Ω at 20°C (68°F)
INSPECTION
FUNCTION AND OPERATION PRICIPLE
Purge Control Solenoid Valve (PCSV) is installed on the surge tank and controls the passage between the canister
and the intake manifold. It is a solenoid valve and is open when the PCM grounds the valve control line. When the
passage is open (PCSV ON), fuel vapors stored in the canister is transferred to the intake manifold.
SPECIFICATION
Item
Specification
Coil Resistance (
Ω)
14.0 ~ 18.0
Ω at 20°C (68°F)
CIRCUIT DIAGRAM
![](/vehicles/jado/eand/bondeakie/lous.png)
COMPONENT INSPECTION
1. Turn ignition switch OFF.
2. Disconnect PCSV connector.
3. Measure resistance between PCSV terminals 1 and 2.
4. Check that the resistance is within the specification.
Specification: Refer to SPECIFICATION.
Fuel Filler cap
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст