Kia Carnival (2007 year). Manual — part 558

Lightly screw the oil filter cap into place, and tighten it until the O-ring contacts the seat.

g. Finally tighten it again by specified tightening torque.

Tightening torque
24.50Nm (2.5kgf.m, 18.08lb-ft)

6. Refill with engine oil.

a. Install the oil drain plug with a new gasket.

Tightening torque
34.3 ~ 44.1Nm (3.5 ~ 4.5kgf.m, 25.3 ~ 32.5lb-ft)

b. Fill with fresh engine oil, after removing the engine oil level gauge.

Capacity
Total : 6.0 L (6.34 US qt, 5.27 lmp qt)
Oil pan : 5.5 L (5.81 US qt, 4.83 lmp qt)
Drain and refill including oil filter : 5.2 L (5.49 US qt, 4.57 lmp qt)
Oil quality : ABOVE API SJ / SL or SAE 5W-20

c. Install the oil filler cap and oil level gauge.

7. Start the engine and check to be sure no oil is leaking from the drain plug or oil filter.

8. Recheck engine oil level.

INSPECTION

1. Check engine oil quality.

Check the oil for deterioration, entry of water, discoloring or thinning.
If the quality is visibly poor, replace the oil.

2. Check engine oil level.

After warming up the engine and then 5 minutes after the engine stop, oil level should be between the "L" and "F"
marks on the dipstick.
If low, check for leakage and add oil up to the "F" mark.

Do not fill with engine oil above the "F" mark.

SELECTION OF ENGINE OIL

Recommended API classification : Above SJ or SL
Recommended SAE viscosity grades : 5W-20
If 5W-20 engine oil is not available, 5W-30 or secondary recommanded engine oil for carrespanding temperature
range can be used.

For best performance and maximum protection of all types of operation, select only those lubricants which :

a. Satisfy the requirement of the API classification.
b. Have proper SAE grade number for expected ambient temperature range.

Lubricants that do not have both an SAE grade number and API service classification on the container should not
be used.

2007 > 3.8L V6 GASOLINE >

COMPONENT

2007 > 3.8L V6 GASOLINE >

REMOVAL

Oil pump

1. Drain engine oil.

2. Using SST(09215-3C000) remove lower oil pan(A).

Be careful not to damage the contact surfaces of upper oil pan and lower oil pan.

3. Remove oil pump chain cover(A).

4. Remove oil pump chain sprocket(A).

5. Remove oil pump(A).