Kia Carnival (2007 year). Manual — part 97

29. Lifting the vehicle up and lowering the jack slowly, remove the transaxle assembly.

INSTALLATION

Installation is in the reverse order of removal.
Perform the following :

a. Adjust the shift cable.

b. Refill the transaxle with fluid.

c. Refill the radiator with engine coolant.

d. Bleed air from the cooling system with the heater valve open.

e. Clean the battery posts and cable terminals with sandpaper, assemble them, and apply grease to prevent

corrosion.

1. Lowering the vehicle or lifting up a jack, install the transaxle assembly.

2. Tighten the transaxle lower mounting bolts (B-4EA).

TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)

3. Install the drive plate bolts (A) by turning the timing gear.

TORQUE:
46~53 Nm(4.6~5.3 kgf.m, 33.3~38.3 lb-ft)

4. After removing a jack, insert the drive shafts. (see DS group)

5. Install the sub frame. (see SS group).

6. Tighten the roll stopper mounting bolts.

TORQUE:
90~110 Nm(9~11 kgf.m, 65.1~79.5 lb-ft)

7. Connect the lower arm, the tie rod end ball joint, the stabilizer bar link to the front knuckle. (see SS group)

8. Install the under cover (A).

9. Install the steering column joint bolt and the VRS connector (A). (see ST group)

10. Connect the return tube(A) with a clamp. (see ST group)

11. Install the front wheels and tires.

12. Tighten the transaxle insulator mounting (B) bolt (A).

TORQUE:
90~110 Nm(9~11 kgf.m, 65.1~79.5 lb-ft)

13. Tighten the transaxle mounting bolts (A).

TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)

14. Remove the SST (09200-38001) holding the engine and transaxle assembly.

15. Install the starter motor. (see EE group).

TORQUE:
65~85 Nm(6.5~8.5 kgf.m, 47.0~61.5 lb-ft)

16. Connect the power steering pressure tube (A) to the power steering oil pump.

17. Connect the transaxle oil cooler hoses (A) to the tubes by fastening the clamps (B).

18. Install the control cable assembly(C) by tightening the nut (A) and clip (B).

TORQUE:
8~12 Nm(0.8~1.2 kgf.m, 5.8~8.6 lb-ft)

19. Install the inhibiter switch connector (A).