Nissan Altima HL32 Hybrid. Manual — part 411
![](/vehicles/gon/sttello/nita/ghent.png)
EXL-44
< COMPONENT DIAGNOSIS >
FRONT FOG LAMP CIRCUIT
NO
>> GO TO 3
3.
CHECK FRONT FOG LAMP OPEN CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between the IPDM E/R harness connector and
the front fog lamp harness connector.
Does continuity exist?
YES
>> GO TO 4
NO
>> Repair the harnesses or connectors.
4.
CHECK FRONT FOG LAMP GROUND CIRCUIT
1. Disconnect the front fog lamp connector.
2. Check continuity between the front fog lamp harness connector
terminal and ground.
Does continuity exist?
YES
>> Inspect the fog lamp bulb.
NO
>> Repair the harness.
A
B
Continuity
Connector
Terminal
Connector
Terminal
RH
E200
86
E227
1
Yes
LH
87
E214
1
ALLIA0123ZZ
Front fog lamp
Ground
Continuity
Connector
Terminal
RH
E227
2
Yes
LH
E214
2
ALLIA0121ZZ
![](/vehicles/gon/sttello/nita/nginthers.png)
PARKING LAMP CIRCUIT
EXL-45
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
PARKING LAMP CIRCUIT
Description
INFOID:0000000004216397
The IPDM E/R (intelligent power distribution module engine room) controls the tail lamp relay based on inputs
from the BCM over the CAN communication lines. When the tail lamp relay is energized, power flows through
fuses 46 and 47, located in the IPDM E/R. Power then flows to the front and rear combination lamps.
Component Function Check
INFOID:0000000004216398
1.
CHECK PARKING LAMP OPERATION
WITHOUT CONSULT-III
1. Activate IPDM E/R auto active test. Refer to
PCS-14, "Diagnosis Description"
.
2. Check that the parking lamp is turned ON.
CONSULT-III
1. Select "EXTERNAL LAMP" of IPDM E/R active test item.
2. With operating the test items, check that the parking lamp is turned ON.
Is the parking lamp turned ON?
YES
>> Parking lamp circuit is normal.
NO
>> Refer to
.
Diagnosis Procedure
INFOID:0000000004216399
1.
CHECK PARKING LAMP FUSES
1. Turn the ignition switch OFF.
2. Check that the following fuses are not open.
Is the fuse open?
YES
>> Repair the harness and replace the fuse.
NO
>> GO TO 2
2.
CHECK TAIL LAMP RELAY OUTPUT (VOLTAGE)
CONSULT-III
TAIL
: Parking lamp ON
OFF
: Parking lamp OFF
Unit
Location
Fuse
Capacity
Parking lamps (front)
IPDM E/R
46
10A
Parking lamps (rear)
IPDM E/R
47
10A
![](/vehicles/gon/sttello/nita/ilemetzee.png)
EXL-46
< COMPONENT DIAGNOSIS >
PARKING LAMP CIRCUIT
1. Turn the ignition switch OFF.
2. Disconnect the front combination lamp connector.
3. Turn the ignition switch ON.
4. Select "EXTERNAL LAMP" of IPDM E/R active test item.
5. With EXTERNAL LAMP ON, check the voltage between the
combination lamp connector and ground.
Is the measurement value normal?
YES
>> GO TO 4
NO
>> GO TO 3
3.
CHECK PARKING LAMP CIRCUIT (OPEN)
1. Turn the ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Check continuity between the IPDM E/R harness connector and
the combination lamp harness connector.
Does continuity exist?
YES
>> GO TO 4
NO
>> Repair the harnesses or connectors.
4.
CHECK PARKING LAMP GROUND CIRCUIT
Terminals
Condition
Voltage
(+)
(
−)
Combination lamp
Ground
External
lamp
Connector
Terminal
Front
A: E218, E225
8
LO
Battery voltage
Rear
B: B30, B45
2
OFF
0V
ALLIA0125ZZ
IPDM E/R
Combination lamp
Continuity
Connector
Terminal
Connector
Terminal
Front
A: E201
91, 92
B: E218, E225
8
Yes
Rear
C: E18
7
D: B30, B45
2
ALLIA0126ZZ
![](/vehicles/gon/sttello/nita/loin.png)
PARKING LAMP CIRCUIT
EXL-47
< COMPONENT DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
1. Disconnect the combination lamp connector.
2. Check continuity between the combination lamp harness con-
nector terminal and ground.
Does continuity exist?
YES
>> Inspect the parking lamp bulb.
NO
>> Repair the harness.
Combination lamp
Ground
Continuity
Connector
Terminal
Front
A: E218, E225
9
Yes
Rear
B: B30, B45
5
ALLIA0127ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст