Nissan Altima HL32 Hybrid. Manual — part 15
AV-52
< ON-VEHICLE REPAIR >
[BASE AUDIO]
AUDIO ANTENNA
4. Remove the roof antenna nut (A), then disconnect the antenna
feeder connector (B) and remove the antenna feeder (1) from
the roof.
5. Detach the antenna feeder harness wire clips, then disconnect
the antenna feeder harness wire end and feed the antenna
feeder harness through the roof to remove the roof antenna
base.
Installation
Installation is in the reverse order of removal.
Window Antenna Repair
INFOID:0000000004219423
ELEMENT CHECK
1. Attach probe circuit tester (ohm setting) to antenna terminal on
each side.
• When measuring continuity, wrap tin foil around the top of
probe. Then, press the foil against the wire with your finger.
ALNIA0127ZZ
SEL250I
SEL122R
AV
AUDIO ANTENNA
AV-53
< ON-VEHICLE REPAIR >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
SEL252I
SEL253I
PIIA0215E
AV-54
< ON-VEHICLE REPAIR >
[BASE AUDIO]
AUDIO ANTENNA
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
SEL012D
SEL013D
AV
STEERING SWITCH
AV-55
< ON-VEHICLE REPAIR >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
STEERING SWITCH
Removal and Installation
INFOID:0000000004219424
REMOVAL
1. Remove the driver airbag module. Refer to
SRS-5, "Removal and Installation"
2. Remove the steering wheel switch assembly screws (A), then
remove the steering wheel switches (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA0045ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст