Nissan Tiida C11. Manual — part 769
![](/vehicles/gon/relug/quto/ethyouithe.png)
EXL-74
< SYMPTOM DIAGNOSIS >
EXTERIOR LIGHTING SYSTEM SYMPTOMS
Daytime light system does not activate.
• Either high beam bulb
• Parking brake switch
• Combination switch
• BCM
• IPDM E/R
• Daytime light relay
• Harness between IPDM E/R
and daytime light relay.
Daytime light system description.
Refer to
XX-XX, "*****"
.
Front fog lamp is not
turned ON.
One side
• Front fog lamp bulb
• Harness between IPDM E/R
and the front combination lamp
• Front combination lamp
• IPDM E/R
Front fog lamp circuit
Refer to
.
Both side
Symptom diagnosis
"BOTH SIDE FRONT FOG LAMPS ARE NOT TURNED ON"
Refer to
Parking lamp is not turned
ON.
One side
• Fuse
• Parking lamp bulb
• Harness between IPDM E/R
and the front/rear combination
lamp
• Front/rear combination lamp
• IPDM E/R
Parking lamp circuit
Refer to
.
Both sides
Symptom diagnosis
"PARKING, LICENSE PLATE AND TAIL LAMPS ARE NOT TURNED
ON"
Refer to
Turn signal lamp does not
blink.
Indicator lamp is nor-
mal.
(The applicable side
performs the high flash-
er activation).
• Harness between BCM and
each turn signal lamp
• Turn signal lamp bulb
• Door mirror (if equipped with
turn signals in the door mirrors)
Turn signal lamp circuit
Refer to
.
Turn signal indicator lamp
does not blink.
One side
Combination meter
—
Both sides
(Always)
• Turn signal indicator lamp sig-
nal
• Combination meter
• BCM
• Combination meter.
Data monitor "TURN IND"
• BCM (FLASHER)
Active test "FLASHER"
Both sides
(Does blink when acti-
vating the hazard warn-
ing lamp with the
ignition switch OFF)
• The combination meter power
supply and the ground circuit
• Combination meter
Combination meter
Power supply and the ground circuit
Refer to
XX-XX, "*****"
.
Symptom
Possible cause
Inspection item
NORMAL OPERATING CONDITION
EXL-75
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
NORMAL OPERATING CONDITION
Description
INFOID:0000000001523288
AUTO LIGHT SYSTEM
The auto light system may not turn the headlamp ON/OFF immediately after passing a dark area or a bright
area (short tunnel, sky bridge, shadowed area etc.). This is normal.
![](/vehicles/gon/relug/quto/pesad.png)
EXL-76
< SYMPTOM DIAGNOSIS >
BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM
BOTH SIDE HEADLAMPS DO NOT SWITCH TO HIGH BEAM
Description
INFOID:0000000001523289
The headlamps (both sides) do not switch to high beam when the lighting switch is in the HI or PASS setting.
Diagnosis Procedure
INFOID:0000000001523290
1.
COMBINATION SWITCH INSPECTION
Check the combination switch. Refer to
XX-XX, "*****"
.
Is the combination switch normal?
YES
>> GO TO 2
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (HI) REQUEST SIGNAL INPUT
CONSULT-III DATA MONITOR
1.
Select "HL HI REQ" of IPDM E/R DATA MONITOR item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3
NO
>> Replace BCM. Refer to
XX-XX, "*****"
.
3.
HEADLAMP (HI) CIRCUIT INSPECTION
Check the headlamp (HI) circuit. Refer to
EXL-33, "HEADLAMP (HALOGEN) : Description"
Is the headlamp (HI) circuit normal?
YES
>> Replace IPDM E/R. Refer to
XX-XX, "*****"
.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL HI REQ
Lighting switch
(2ND)
HI or PASS
ON
Except for HI or
PASS
OFF
![](/vehicles/gon/relug/quto/xxhousiver.png)
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
EXL-77
< SYMPTOM DIAGNOSIS >
C
D
E
F
G
H
I
J
K
M
A
B
EXL
N
O
P
BOTH SIDE HEADLAMPS (LO) ARE NOT TURNED ON
Description
INFOID:0000000001523291
The headlamps (both sides) do not turn ON in any lighting switch setting.
Diagnosis Procedure
INFOID:0000000001523292
1.
CHECK COMBINATION SWITCH
Check the combination switch. Refer to
XX-XX, "*****"
.
Is the combination switch normal?
YES
>> GO TO 2
NO
>> Repair or replace the malfunctioning part.
2.
CHECK HEADLAMP (LO) REQUEST SIGNAL INPUT
CONSULT-III DATA MONITOR
1.
Select "HL LO REQ" of IPDM E/R DATA MONITOR item.
2.
With operating the lighting switch, check the monitor status.
Is the item status normal?
YES
>> GO TO 3
NO
>> Replace BCM. Refer to
XX-XX, "*****"
.
3.
HEADLAMP (LO) CIRCUIT INSPECTION
Check the headlamp (LO) circuit. Refer to
EXL-37, "HEADLAMP (HALOGEN) : Description"
.
Is the headlamp (LO) circuit normal?
YES
>> Replace IPDM E/R. Refer to
XX-XX, "*****"
.
NO
>> Repair or replace the malfunctioning part.
Monitor item
Condition
Monitor status
HL LO REQ
Lighting switch
2ND
ON
OFF
OFF
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст