Nissan Murano. Manual — part 749
EXT-34
< REMOVAL AND INSTALLATION >
ROOF SIDE MOLDING
CAUTION:
To install roof side molding, check if all clips are matched over holes of panel on vehicle, then push it.
SUNROOF
SUNROOF : Exploded View
INFOID:0000000009720587
SUNROOF : Removal and Installation
INFOID:0000000009720588
REMOVAL
1.
Remove roof rail assembly and roof rail center leg assembly. (with ROOF RAIL)
Refer to
EXT-31, "Removal and Installation"
.
2.
Disengage roof side molding (1) fixing clips with remover tool
(A).
CAUTION:
Apply protective tape (B) around the roof side molding.
1.
Roof side molding
2.
Roof side molding clip
: Clip
: Always replace after every disassembly.
JMKIA2020ZZ
: Clip
JMKIA2019ZZ
ROOF SIDE MOLDING
EXT-35
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Insert front end of roof side molding (1) into roof side finisher.
• To install roof side molding, check if all clips are matched over holes of panel on vehicle, then push
it.
JMKIA2021ZZ
EXT-36
< REMOVAL AND INSTALLATION >
DOOR OUTSIDE MOLDING
DOOR OUTSIDE MOLDING
Exploded View
INFOID:0000000009720589
Removal and Installation
INFOID:0000000009720590
REMOVAL
FRONT DOOR OUTSIDE MOLDING
1.
Fully open door window.
2.
Insert a remover tool (A) into lower space.
3.
Disengage pawls of fixing front door outside molding (1) with
thin flat blade screw driver (B).
CAUTION:
Apply protection tape (C) around outer circumference of
front door.
1.
Front door outside molding
2.
Front door assembly
3.
Rear door outside molding
4.
Rear door assembly
: Pawl
: Always replace after every disassembly.
JMKIA2022ZZ
: Pawl
JMKIA2023ZZ
DOOR OUTSIDE MOLDING
EXT-37
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
L
M
A
B
EXT
N
O
P
4.
Twist and pull up to upper side, and then remove front door out-
side molding (1).
REAR DOOR OUTSIDE MOLDING
1.
Fully open door window.
2.
Insert a remover tool (A) into lower space.
3.
Disengage pawls of fixing rear door outside molding (1) with flat
blade screw driver (B).
CAUTION:
Apply protection tape (C) around outer circumference of
rear door.
4.
Twist and pull up to upper side, and then remove rear door out-
side molding (1).
INSTALLATION
Install in the reverse order of removal.
JMKIA2024ZZ
: Pawl
JMKIA2025ZZ
JMKIA2026ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст