Nissan Qashqai J11. Manual — part 1674
![](/vehicles/gon/ffua/inoowhem/eveyojen.png)
INSIDE MIRROR
MIR-71
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
1.
Hold inside mirror at the base and push upward, while using a
suitable tool to release the pawl and remove.
CAUTION:
Use care when removing inside mirror to avoid damage to
mirror, mirror base or windshield glass.
Installation
Installation is in the reverse order of removal.
CAUTION:
Apply Genuine Mirror Adhesive or equivalent to bonding surface of mirror base if loose or removed.
AUTO ANTI-DAZZLING
Removal
1.
Remove inside mirror finisher.
2.
Disconnect the harness connector from the inside mirror.
3.
Loosen bolt and slide inside mirror upward to remove.
Installation
Installation is in the reverse order of removal.
• Calibrate compass (if equipped).
CAUTION:
Apply Genuine Mirror Adhesive or equivalent to bonding surface of mirror base if loose or removed.
NOTE:
Calibrate the compass by driving the vehicle in a complete circle three times.
ALLIA1034ZZ
![](/vehicles/gon/ffua/inoowhem/vingut.png)
MIR-72
< REMOVAL AND INSTALLATION >
DOOR MIRROR
DOOR MIRROR
Exploded View
INFOID:0000000010478221
Removal and Installation
INFOID:0000000010478222
REMOVAL
1.
Remove front door finisher. Refer to
INT-12, "FRONT DOOR FINISHER : Removal and Installation"
.
2.
Release door mirror corner finisher clips using a suitable tool.
3.
Disconnect the harness connector from the blind spot warning indicator (if equipped), then remove the
door mirror corner finisher.
4.
Disconnect the harness connector from the door mirror.
5.
Remove door mirror nuts and door mirror.
1.
Door mirror
2.
Door mirror corner finisher
3.
Door mirror rear finisher
4.
Side turn signal lamp
5.
Side camera (if equipped)
6.
Door mirror glass
Pawl
ALLIA1382ZZ
![](/vehicles/gon/ffua/inoowhem/lanfr.png)
DOOR MIRROR
MIR-73
< REMOVAL AND INSTALLATION >
C
D
E
F
G
H
I
J
K
M
A
B
MIR
N
O
P
6.
Remove screws (A) and side camera (1) (if equipped) (if neces-
sary) from door mirror rear finisher (2).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Perform camera image calibration (if equipped with around view camera). Refer to
BRATING CAMERA IMAGE (AROUND VIEW MONITOR) : Work Procedure"
.
ALLIA1383ZZ
![](/vehicles/gon/ffua/inoowhem/rtheriedders.png)
MIR-74
< REMOVAL AND INSTALLATION >
DOOR MIRROR REMOTE CONTROL SWITCH
DOOR MIRROR REMOTE CONTROL SWITCH
Removal and Installation
INFOID:0000000010478226
REMOVAL
1.
Release pawls using a suitable tool and remove front door pull handle (LH). Refer to
.
2.
Release pawls (B) using a suitable tool and remove door mirror
remote control switch (1).
3.
Remove screws (A) and door mirror remote control switch
bracket (2) (if necessary).
INSTALLATION
Installation is in the reverse order of removal.
ALLIA1384ZZ
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст