Daewoo Matiz (2003 year). Manual — part 141

ANTILOCK BRAKE SYSTEM 4F – 13

COMPONENT LOCATOR

ABS

D17E401A

1. Hydraulic Modulator Unit
2. Electronic Brake Control Module (EBCM)
3. Bolt
4. Upper Mounting Bracket
5. Grommet

6. Lower Mounting Bracket
7. Bracket Grommet
8. Rear Wheel Speed Sensor
9. Front Wheel Speed Sensor

4F – 14 ANTILOCK BRAKE SYSTEM

ABS (Cont’d)

D17E402A

ANTILOCK BRAKE SYSTEM 4F – 15

BLANK

4F – 16 ANTILOCK BRAKE SYSTEM

DIAGNOSTIC INFORMATION AND PROCEDURES

D17E301A

DIAGNOSTIC TROUBLE CODE (DTC) 0354

LEFT FRONT WHEEL SPEED SENSOR CIRCUIT OPEN OR SHORTED

Circuit Description

As a toothed ring passes by the wheel speed sensor,
changes in the electromagnetic field cause the wheel
speed sensor to produce a sinusoidal (AC) voltage sig-
nal whose frequency is proportional to the wheel speed.
The magnitude of this signal is directly related to wheel
speed and the proximity of the wheel speed sensor to
the toothed ring often referred to as the air gap.

Diagnosis

This test detects a short to battery, ground, or open in
the left front wheel speed sensor circuit.

Cause(s)

D

The wheel speed circuit is open or shorted to the bat-
tery or ground.

D

There is a loose connection in the wheel speed cir-
cuit.

D

The wheel speed sensor resistance is very high.

D

The EBCM is malfunctioning.

Fail Action

This is a critical operational fault. The ABS is disabled
and the ABS warning lamp is turned on. The proportion-
ing is operation.

Diagnostic Aids

An ‘‘intermittent’’ malfunction may be caused by a poor
connection, rubbed through wire insulation, or a wire
that is broken inside the insulation.

Thoroughly check any circuitry suspected of causing the
intermittent complaint. Look for backed out terminals,
improper mating, broken locks, improperly formed or
damaged terminals, poor terminal to wiring connections,
or physical damage to the wiring harness.

Wheel speed sensor resistance will increase as the sen-
sor temperature increases.

When replacing a wheel speed sensor, inspect the sen-
sor terminals and harness connector for corrosion and/
or water intrusion. If evidence of corrosion or water