Daewoo Musso. Manual — part 214
![](/vehicles/epme/qux/oho/ddd.png)
2E-4 TIRES AND WHEELS
COMPONENT LOCATOR
WHEEL AND TIRE
1 Wheel Bolts . . . . . Steel Wheel : 80-120 Nm
. . . . . . .. Aluminium Wheel : 110-130 Nm
2 Steel Wheel
3 Aluminium Wheel
4 Tire
5 Steel Wheel Weight Balance
6 Hub Cap
![](/vehicles/epme/qux/oho/jat.png)
TIRES AND WHEELS 2E-5
MAINTENANCE AND REPAIR
ON-VEHICLE SERVICE
WHEELS AND TIRES
Removal & Installation Procedure
1. Inspection of tire
Check tread area for tread surface, crack, damage by nail
in or stones. Replace or repair if necessary.
l
Replace the tire if tread-wear indicator of the tread
grooves appears where marked ' '
.
l
The wear limit of snow tire is the same as normal tire
(1.6mm) and indicator location is marked '
¯
'
.
Limit
1.6mm
Standard
2.66mm
Standard
2.03mm
2. Wear limit.
3. Runout measurement.
l
Excessive runout of tires and wheels can cause the
abnormal wear of tire. Using a dial indicator, measure
wheel and tire runout.
l
Measure radial runout at the rim flange and center of
the tire tread area.
l
Measure lateral runout at the tire bead area of the wheel
and tire sidewall.
Notice
If runout is excessive, replace the tire or wheel.
![](/vehicles/epme/qux/oho/ging.png)
2E-6 TIRES AND WHEELS
4. Tire pressure inspection.
l
Tire pressure.
l
Check tread contact with road.
Notice
l
If underinflated, tire may come away from the wheel
during rapid steering.
l
An overinflated tire will cause a hard riding and uneven
wear.
Front & Rear
(P235/75R15)
2.1kg/cm (30PSI)
2
5. Wheel balance.
l
Balance weights should be on each side. When the wheel
is out of balance or a tire has been repaired, be sure to
balance the wheel again.
l
If total weight is over 150g, readjust the balance by
reinstalling the tire on the wheel.
l
Balance weight should not protrude from the wheel rim
over 3mm.
l
For aluminum wheel, use aluminum wheel balance weight
only.
![](/vehicles/epme/qux/oho/ndlis.png)
TIRES AND WHEELS 2E-7
l
To correct unbalance, install equal weights 180° opposite
each other, one on the inside of the wheel and one on
the outside, at the point of unbalance.
l
Balance Weight
6. Cautions for installation and removal.
l
Clean the mounting surfaces of hub and wheel.
l
Do not apply grease or oil on the nuts and bolts (It will
cause looseness and poor tightening).
l
Using a jack, lift up the tire about 3cm from the ground.
l
Tighten nuts in a criss-cross pattern 2-3 times.
10g
0.4oz
20g
0.7oz
30g
1.10oz
40g
1.40oz
50g
1.80oz
60g
2.1oz
Steel : 80 - 120Nm
Aluminium : 110 - 130Nm
Tighten Torque
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст