Daewoo Musso. Manual — part 40
![](/vehicles/epme/qux/oho/rerelorm.png)
1B1-96 M162 ENGINE MECHANICAL
3 Oil Filler Cap
4 Dipstick Gauge
9. Fill up engine oil through the engine oil filler opening (3).
10. Check for oil leaks at normal engine temperature after
starting the engine.
11. Stop the engine and wait 5 minutes.
Check the oil level and fill up as specified if necessary.
![](/vehicles/epme/qux/oho/sipur.png)
M162 ENGINE MECHANICAL 1B1-97
OIL FILTER
Preceding Work : Removal of starter motor
Removal of upper intake manifold
1 Coolant Line
2 O-ring . . . . . . . . . . . . . Replace
3 Clip
4 Hose
5 Bolt . . . . . . . . . . . . . . ... 23 Nm
6 Oil Filter
7 Gasket . . . . . . . . . . . . ... Replace
![](/vehicles/epme/qux/oho/stre.png)
1B1-98 M162 ENGINE MECHANICAL
Tightening Torque
23 Nm
Notice
Replace the oil filter gasket.
4. Installation should follow the removal procedure in the
reverse order.
5. Check engine oil level.
6. Run the engine at idle and check the engine for leaks.
3. Remove the oil filter bolt and then remove the oil filter.
Installation Notice
Removal & Installation Procedure
1. Drain the coolant from the crank case.
2. Remove the each coolant line and hose.
![](/vehicles/epme/qux/oho/vee.png)
M162 ENGINE MECHANICAL 1B1-99
1 Bolt (M8 x 20, 1 piece) . . . . . . . 29-35 Nm
2 Sprocket (Oil Pump Drive)
3 Bolt (M8 x 35, 3 pieces) . . . . . 22.5-27.5 Nm
OIL PUMP
Preceding Work : Removal of oil pan
4 Spring Pin
5 Oil Pump
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст