Chery Tiggo 5 (T21). Service manual — part 291
26–
19
26
Vacuum Booster with Brake Master Cylinder Assembly
On-vehicle Inspection
1. Check vacuum booster assembly.
a. Air tightness check.
Start engine and stop it after 1 or 2 minutes. Slowly depress brake pedal several times.
Make sure that booster is airtight. Check that distance every time the pedal depressed is gradually
decreased compare to the previous operation.
If pedal operation is not as specified, check the check valve. If check valve is normal, replace the
vacuum booster assembly.
Start engine. Depress and hold pedal, then stop engine.
Make sure that booster is airtight. Depress and hold pedal for 30 seconds, and check that pedal
reserve distance does not change.
If pedal operation is not as specified, check the check valve. If check valve is normal, replace the
vacuum booster assembly.
b. Operation check.
Stop engine.
Depress pedal several times and check that pedal
reserve distance does not change.
Depress and hold pedal, and then start engine.
Check that pedal can only be depressed lightly.
If pedal operation is not as specified, check the
check valve. If check valve is normal, replace the
vacuum booster assembly.
RT21260160
RT21260170
26–
20
26
Removal
1. Drain the brake fluid (
).
2. Remove the air filter assembly (
).
3. Remove the vacuum booster with brake master cylinder assembly.
a. Loosen the brake fluid tube fixing clamp (arrow) and
disengage the brake fluid tube from brake fluid
reservoir assembly.
b. Loosen the clutch hose fixing clamp (arrow) and
disengage the clutch hose from brake fluid reservoir
assembly (for only MT model).
c. Loosen 2 coupling plugs (arrow) between brake
master cylinder assembly and brake pipes.
(Tightening torque: 16 ± 2 N·m)
CAUTION
Wash off brake fluid immediately if it comes in contact with any paint surface.
ENVIRONMENTAL PROTECTION
Drained brake fluid should be well kept in a container. Never discard it at will.
RT21260100
RT21260110
RT21260120
26–
21
26
d. Disengage the vacuum hose assembly with check
valve (arrow) from vacuum booster assembly.
e. Using needle-nose pliers, remove the locking pin
(arrow) and pushrod pin (1) from vacuum booster
pushrod, and detach the brake pedal assembly.
f. Remove 4 coupling nuts (arrow) between vacuum
booster assembly and brake pedal assembly.
(Tightening torque: 25 ± 3 N·m)
g. Remove the vacuum booster with brake master
cylinder assembly from engine compartment.
RT21260180
1
RT21260190
RT21260200
RT21260210
26–
22
26
Inspection
1. Check the check valve.
a. Remove the check valve from vacuum hose assembly.
b. Check that there is airflow (A) from vacuum booster to
engine, and no airflow (B) from engine to vacuum
booster.
If result is not as specified, replace vacuum hose
assembly.
Installation
Installation is in the reverse order of removal.
B
A
RT21260220
CAUTION
Make sure to tighten fixing plugs and nuts to the specified torque during installation.
Perform bleeding procedures for brake system and add brake fluid to proper level after completing
installation.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст