Chery Tiggo 5 (T21). Service manual — part 469
43–
56
43
d. Disconnect the connector (arrow) from power glass
regulating switch assembly, and remove the left power
glass regulating switch assembly.
4. Remove the left power glass regulating switch.
a. Using a screwdriver wrapped with protective tape, pry
up the claws (arrow) on power glass regulating switch,
and remove the left power glass regulating control
switch.
RT21430220
RT21430230
43–
57
43
Inspection
1. Check power glass regulating switch.
a. Using a digital multimeter, check for continuity of
power glass regulating switch according to the table
below.
If result is not as specified, replace power glass
regulating switch.
2. Check power glass regulating switch illumination.
a. Apply battery voltage to the terminals of power glass
regulating switch connector, and check the operation
of power glass regulating switch according to the table
below.
If result is not as specified, replace power glass
regulating switch.
Installation
Installation is in the reverse order of removal.
6 7 8 9
1 2 3 4 5
10
-
+
RT21430240
Area
Multimeter
Connection
Switch
Condition
Specified
Condition
Front right door
glass regulating
switch
6 - 9
UP
220 Ω
OFF
No continuity
6 - 9
DOWN
Continuity
OFF
No continuity
Rear left door
glass regulating
switch
6 - 9
UP
220 Ω
OFF
No continuity
6 - 9
DOWN
Continuity
OFF
No continuity
Rear right door
glass regulating
switch
6 - 9
UP
220 Ω
OFF
No continuity
6 - 9
DOWN
Continuity
OFF
No continuity
-
+
6 7 8 9
1 2 3 4 5
10
RT21430241
Measurement Condition
Specified
Condition
Battery positive
(+)
Battery negative
(-)
1
3
LED comes on
CAUTION
Check if connector is correctly installed when installing power glass regulating switch.
Check if switch operates normally after installing power glass regulating switch.
43–
58
43
Rear Door Outer Weather bar
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the rear left door outer weather bar.
a. Remove the rear left door frame weatherstrip.
HINT:
It is not necessary to remove the rear left door weatherstrip completely. There is a fixing screw in the
rear door weatherstrip.
b. Remove 2 fixing screws (arrow) from rear door outer
weather bar.
(Tightening torque: 1.3 ± 0.2 N·m)
c. Remove the rear left door outer weather bar in the
direction of arrow as shown in the illustration.
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing rear door outer weather bar.
Appropriate force should be applied when removing rear door outer weather bar. Be careful not to
operate roughly.
Try to prevent body paint surface from being scratched when removing rear door outer weather bar.
RT21430180
RT21430190
43–
59
43
Rear Door Glass Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear door outer weather bar (
).
4. Remove the rear left door protector assembly (
).
5. Remove the rear left door assist grip mounting bracket assembly (
6. Remove the rear left door protective film assembly (
7. Remove the rear door glass rear guide rail assembly (
).
8. Remove the rear left door glass run.
a. Lower the rear door glass assembly and pull out the
rear left door glass run from the slot.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing rear door glass assembly.
Appropriate force should be applied when removing rear door glass assembly. Be careful not to operate
roughly.
When removing the rear door glass assembly, avoid the window glass from dropping and becomes
damaged.
RT21430250
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст