Chery Tiggo 5 (T21). Service manual — part 295
26–
35
26
b. Install the brake cylinder dust boot to the brake
cylinder.
4. Install the brake lining support gasket.
a. Securely install the upper and lower support gaskets
(arrow) onto the brake caliper fixing bracket.
5. Install the front brake lining.
a. Securely install the inner brake lining and outer brake
lining (arrow) onto the brake caliper fixing bracket.
Make sure they are clamped in place.
RT21260480
CAUTION
Securely install brake cylinder dust boots into front ring grooves (both sides) of disc brake cylinder.
DO NOT damage brake cylinder dust boot.
RT21260400
RT21260390
CAUTION
Make sure the contact surface of lining and brake disc is free of oil and grease.
26–
36
26
6. Install the front brake caliper locating bolt guide pin (w/ dust boot).
a. Apply a small amount of grease to the contact surface
between locating bolt guide pins and guide pin rubber
dust boots, and securely install the dust boots (arrow)
to the brake caliper fixing bracket.
7. Install the brake cylinder assembly.
a. Using brake cylinder piston pressing tool, slightly
retract the brake cylinder piston (both sides).
b. Align the brake caliper locating bolts (arrow) with the
guide pin hole and securely install the brake cylinder
assembly.
(Tightening torque: 25 ± 3 N·m)
8. Install the bleeder plug (w/ bleeder plug cap).
a. Securely install the bleeder plug (w/ bleeder plug cap)
(arrow) to the front brake caliper assembly.
(Tightening torque: 9 - 11 N·m)
RT21260380
RT21260490
RT21260370
RT21260360
26–
37
26
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to tighten fixing bolts and nuts to the specified torque during installation.
Before installing brake linings, completely retract brake caliper piston back into the bore of brake caliper.
Depress brake pedal several times to secure the brake linings to brake disc in order to ensure safety
after installing the brake linings and before moving vehicle.
Replace brake linings in pairs. DO NOT replace it alone.
DO NOT install inner brake lining and outer brake lining reversely.
Be sure to check brake system for leakage after installation. Repair or replace malfunctioning parts as
necessary.
Be sure to perform bleeding procedures for brake system after installation.
Be sure to add brake fluid to the proper level after installation.
26–
38
26
Front Brake Hose Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the front left wheel (
2. Drain the brake fluid (
).
3. Remove the front left brake hose assembly.
a. Disengage the fixing clamp (arrow) and loosen the
coupling plug (1) between front left brake hose
assembly and front left brake pipe.
(Tightening torque: 16 ± 2 N·m)
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when repairing.
Try to prevent body paint surface from being scratched during removal and installation.
CAUTION
Wash off brake fluid immediately if it comes in contact with any paint surface.
ENVIRONMENTAL PROTECTION
Drained brake fluid should be well kept in a container. Never discard it at will.
1
RT21260500
CAUTION
DO NOT bend or damage brake tube.
DO NOT allow any foreign matter such as dirt and dust to enter brake tube from joint parts.
After removing brake line, perform sealing treatment to prevent foreign matter from entering.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст