Jaguar XJ (X350). Service manual — part 55
27 . NOTE:
Left-hand shown, right-hand similar.
Remove the front subframe rear retaining bolt.
28 . Lower the special tool by approximately 200 mm (7.9 in).
29 . NOTE:
Left-hand shown, right-hand similar.
Remove the stabilizer bar clamp.
30 . Remove the stabilizer bar.
Installation
1 . Install the stabilizer bar
2 . NOTE:
Left-hand shown, right-hand similar.
Install the stabilizer bar clamp.
Tighten to 55 Nm.
3 . Using the special tool, install the front subframe.
www.
4 . Check the front subframe alignment.
5 . NOTE:
Left-hand shown, right-hand similar.
Install the front subframe front retaining bolt.
Tighten to 200 Nm.
6 . NOTE:
Left-hand shown, right-hand similar.
Install the front subframe rear retaining bolt.
Tighten to 115 Nm.
7 . Remove the special tool.
8 . NOTE:
Left-hand shown, right-hand similar.
Attach the engine mount.
Tighten to 55 Nm.
9 . NOTE:
Left-hand shown, right-hand similar.
Attach the air spring assembly.
Tighten to 175 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст