Jaguar XJ (X350). Service manual — part 633
5 . NOTE:
Cap the coolant hoses to minimize coolant loss.
Detach the coolant hoses from the throttle body.
6 . Remove the throttle body.
7 . Remove and discard the O-ring seal.
Installation
1
.
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle
plate has a special coating applied during manufacture which should not be removed.
To install, reverse the removal procedure.
Install a new O-ring seal.
2 . Tighten to 10 Nm.
3 . Check and top up the cooling system as required.
www.
Throttle Body - VIN Range: G45704-
>G99999 (19.70.04)
Removal
1
.
WARNING: When relieving cooling system pressure, cover the expansion tank cap
with a thick cloth to prevent the possibility of scalding. Failure to follow these instructions
may result in personal injury.
Remove the expansion tank cap to relieve the cooling system pressure.
2
.
CAUTION: Do not attempt to clean the throttle body. The bore and the throttle
plate has a special coating applied during manufacture which should not be removed.
Remove the air cleaner outlet pipe.
For additional information, refer to
3 . Disconnect the throttle body electrical connector.
4 . NOTE:
Clamp the coolant hose to minimize coolant loss.
Disconnect the coolant hose.
5 . NOTE:
Clamp the coolant hose to minimize coolant loss.
Disconnect the coolant hose.
6 . Remove the throttle body.
7 . Remove and discard the O-ring seal.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст