Jaguar XJ (X350). Service manual — part 1555
![](/vehicle/yohir/vahe/meloningh/halwavekubre.png)
Remove the rear fender splash shield retaining screw.
9 . NOTE:
Right-hand shown, left-hand similar.
Detach the fender splash shield.
10 . Remove the bumper cover lower retaining screws.
11 . NOTE:
Right-hand shown, left-hand similar.
Disconnect the tire pressure monitoring system rear antenna electrical connector.
![](/vehicle/yohir/vahe/meloningh/ilousancho.png)
12 . NOTE:
Left-hand shown, right-hand similar.
Detach the rear bumper cover.
Detach the bumper cover from the retaining clips.
13 . Remove the rear bumper.
Detach the wiring harness grommet from the rear quarter panel.
Installation
1 . To install, reverse the removal procedure.
Tighten to 6 Nm.
www.
![](/vehicle/yohir/vahe/meloningh/llon.png)
![](/vehicle/yohir/vahe/meloningh/ken.png)
Rear Bumper Cover Insert (76.22.75)
Removal
1
.
Remove the rear bumper cover.
For additional information, refer to Rear Bumper Cover - VIN Range: G00442-
>H18679 (76.22.74)
2 . Remove the bumper cover insert.
Remove the bumper cover insert retaining clips.
Installation
1 . To install, reverse the removal procedure.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст