Jaguar XJ (X350). Service manual — part 966
Installation
1
.
CAUTION: Do not twist the H02S wiring harness on installation. Failure to follow this
instruction may result in damage to the component.
To install, reverse the removal procedure.
Tighten to 40 Nm.
Intake Air Temperature (IAT) Sensor - 4.2L
SC V8 - AJV8 (18.30.52)
Removal
1 . Remove the engine cover.
2 . Disconnect the intake air temperature (IAT) sensor electrical connector.
3 . Remove the IAT sensor.
Remove and discard the IAT sensor sealing washer.
www.
Installation
1 . To install, reverse the removal procedure.
Install a new IAT sensor sealing washer.
Tighten to 35 Nm.
Knock Sensor (KS) LH (18.30.92)
Removal
Vehicles with supercharger
1 . Remove the supercharger.
For additional information, refer to
For additional information, refer to
2 . Remove the noise isolator.
Vehicles without supercharger
3 . Remove the intake manifold.
For additional information, refer to
For additional information, refer to
All vehicles
4 . Remove the knock sensor (KS).
Installation
1 . To install, reverse the removal procedure.
Tighten to 25 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст