Jaguar XJ (X350). Service manual — part 296
NOTE:
When performing voltage or resistance tests, always use a digital multimeter (DMM) accurate to
three decimal places and with a current calibration certificate. When testing resistance, always
take the resistance of the DMM leads into account.
NOTE:
Check and rectify basic faults before beginning diagnostic routines that involve pinpoint tests.
NOTE:
Inspect connectors for signs of water ingress, and pins for damage and/or corrosion.
NOTE:
If DTCs are recorded and, after performing the pinpoint tests, a fault is not present, an
intermittent concern may be the cause. Always check for loose connections and corroded
terminals.
DTC
Description
Possible Causes
Action
B1342 ECU is defective
•
Steering column lock
module - failure
Steering column lock module electronic
failure. Suspect faulty module, check
and install as required, refer to the new
module installation note at the top of
the DTC Index
B2162
Instrument
Cluster ID does
not match
•
Stored vehicle
identification details
incorrect
Steering column lock module electronic
failure. Configure steering column lock
module (Must enable SCLM and
instrument cluster to transfer ID) i.e.
Configure as for replacement new
module
B2168
Unable to
confirm
unlocked
condition
•
Steering column lock
module - failure (cannot
complete unlock
command)
Steering column lock module
mechanical failure. Suspect faulty
module, check and install as required,
refer to the new module installation
note at the top of the DTC Index
B2169
Unable to
confirm locked
condition
•
Steering column lock
module - failure (cannot
complete lock command)
Steering column lock module
mechanical failure. Suspect faulty
module, check and install as required,
refer to the new module installation
note at the top of the DTC Index
B2375
Hall Sensor
Failed in
Unlocking
Direction
•
Steering column lock
module - hall sensor
failure
Steering column lock module failure.
Suspect faulty module, check and install
as required, refer to the new module
installation note at the top of the DTC
Index
B2376
Lock Cycle -
Timing Invalid
•
Steering column lock
module - failure (Lock :
Time between Unlock
Edge to Lock edge is too
short)
Steering column lock module failure.
Suspect faulty module, check and install
as required, refer to the new module
installation note at the top of the DTC
Index
B2377
Unlock Cycle -
Timing Invalid
•
Steering column lock
module - failure (Unlock :
Time between Lock Edge
to Unlock edge is too
short)
Steering column lock module failure.
Suspect faulty module, check and install
as required, refer to the new module
installation note at the top of the DTC
Index
B2378
Hall Sensor
Failed in
Locking
Direction
•
Steering column lock
module - hall sensor
failure
Steering column lock module failure.
Suspect faulty module, check and install
as required, refer to the new module
installation note at the top of the DTC
Index
B2379
SCLM not
configured
(inhibited
mode)
•
Steering column lock
module is not configured
(set after first unlock
command)
Configure steering column lock module
(Must enable SCLM and instrument
cluster to transfer ID)
www.
Removal and installation
Steering Column Lock Actuator (57.40.41)
Special Service Tools
5 point security torx bit
418-535
Removal
1 . Remove the steering column.
2
.
Remove the steering column lock actuator.
Using the special tool, remove the steering column lock actuator retaining
bolts.
Installation
1 . To install, reverse the removal procedure.
Tighten to 9 Nm.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст