Jaguar XJ (X350). Service manual — part 1184
Operate the brake pedal to allow the speed control deactivator switch to
remain in the fully extended position during installation.
Releasing and then pulling back on the pedal untill the pedal reaches the
stop in the brake booster, will adjust the speed control de-activator switch
plunger to the required setting.
Speed Control Module (19.75.26)
Removal
1
.
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to
these charges, damage may result.
NOTE:
Make sure the audio unit keycode is available before disconnecting the battery ground
cable.
Disconnect the battery ground cable.
For additional information, refer to Battery Disconnect and Connect
2 . Remove the driver side instrument panel lower trim.
3 . Remove the instrument panel trim.
4 . Disconnect the speed control module electrical connector.
www.
5 . Remove the speed control module.
Remove the speed control module retaining nuts.
Installation
1 . Install the speed control module.
Tighten to 5 Nm.
2 . Connect the speed control module electrical connector.
3 . Install the instrument panel trim.
4 . Install the driver side instrument panel lower trim.
5 . Connect the battery ground cable.
For additional information, refer to Battery Connect (86.15.15)
6 . Using the approved Jaguar diagnostic system configure the speed control module.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст