Jaguar XJ (X350). Service manual — part 134
![](/vehicle/yohir/vahe/souieto/yort.png)
3 . NOTE:
This step is for front air suspension height sensors only.
Detach the wheel speed sensor harness.
4 . NOTE:
Front shown, rear similar.
Detach the front air suspension height sensor link rod.
![](/vehicle/yohir/vahe/souieto/ashoroue.png)
Front shown, rear similar.
Remove the front air suspension height sensor.
Remove the front air suspension height sensor retaining bolts.
Installation
1 . To install, reverse the removal procedure.
Tighten to 20 Nm.
2
.
NOTE:
To aid installation of the electrical connector, apply a small amount of silicone based oil
or grease to the connector seal.
NOTE:
Make sure the electrical connector latch is fully secured to the sensor.
5 . NOTE:
www.
![](/vehicle/yohir/vahe/souieto/torou.png)
Connect the front air suspension height sensor electrical connector.
3 . Re-calibrate the suspension height sensor using the Jaguar approved diagnostic system.
For additional information, refer to
Ride Height Adjustments
![](/vehicle/yohir/vahe/souieto/icu.png)
205 : Driveline
205-00 : Driveline System – General Information
General procedures
Driveline Angle Inspection
Special Service Tools
Alignment Tool
205-535
1. Raise and support the vehicle.
3. Remove the support bracket.
4. Remove the driveshaft heat shield.
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст