Jaguar XJ (X350). Service manual — part 1085
Remove and discard the gasket.
Installation
1
.
CAUTION: Make sure the catalytic converter is fully supported during installation.
Failure to follow this instruction will result in damage to the catalytic converter decoupler
joint.
CAUTION: Never use jointing compound forward of the catalytic converter.
NOTE:
Right-hand shown, left-hand similar.
Loosely install the catalytic converter.
Install a new gasket.
Install the retaining bolts.
2 . NOTE:
Right-hand shown, left-hand similar.
Install new retaining nuts.
Tighten to 22 Nm.
3 . NOTE:
Right-hand shown, left-hand similar.
Install the catalytic convertor to particulate filter retaining clamp.
Tighten to 11 Nm.
www.
4 . NOTE:
Right-hand shown, left-hand similar.
Fully tighten the catalytic converter bracket retaining bolts.
Tighten to 25 Nm.
NOTE:
For vehicles prior to VIN H16767, refit old fixings and tighten to 22 Nm.
5 . NOTE:
Right-hand shown, left-hand similar.
Attach the catalytic converter temperature sensor wiring harness to the transmission.
6 . NOTE:
Right-hand shown, left-hand similar.
Connect the catalytic converter temperature sensor electrical connectors.
7 . Install the air deflector.
For additional information, refer to Air Deflector (76.11.41)
www.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст