Lexus SC300 / Lexus SC400. Service manual — part 802
![](/vehicle/tus/kendre/chaul/pld.png)
DIAGNOSTIC CHART
DIAGNOSTIC CHART
Troubleshooting for this system is different for when the SRS warning light does not light up and for when diag-
nostic trouble code 22 is output. Confirm the problem symptoms first before selecting the appropriate trouble-
shooting procedure.
HINT: If SRS warning light does not light up, perform the following troubleshooting:
–
SUPPLEMENTAL RESTRAINT SYSTEM
TROUBLESHOOTING
RS–103
![](/vehicle/tus/kendre/chaul/istoy.png)
WIRING DIAGRAM
DIAGNOSTIC CHART
DIAGNOSTIC CHART
HINT: If diagnostic trouble code 22 is output, perform the following troubleshooting:
).
RS–104
–
SUPPLEMENTAL RESTRAINT SYSTEM
TROUBLESHOOTING
![](/vehicle/tus/kendre/chaul/etin.png)
OK
NG
OK
NG
INSPECTION PROCEDURE
HINT: If SRS warning light does not light up, perform the following troubleshooting:
1
Check ECU–B fuse.
Go to step
2
Preparation.
P
1.
Disconnect battery negative (–) terminal cable, and
wait at least 90 seconds.
2.
Remove steering wheel pad (See page
3.
Disconnect connectors of front passenger airbag
assembly (See page
Caution:
Store the steering wheel pad with the
surface facing upward.
3
Check connection of center airbag sensor assembly connector.
Repair.
–
SUPPLEMENTAL RESTRAINT SYSTEM
TROUBLESHOOTING
RS–105
![](/vehicle/tus/kendre/chaul/pam.png)
OK
NG
YES
NO
YES
NO
4
Check SRS warning light circuit.
C
OK
P
1.
Disconnect center airbag sensor assembly.
2.
Connect negative (–) terminal cable to battery.
3.
Turn ignition switch ACC or ON.
Measure voltage LA terminal of harness side connector
of center airbag sensor assembly.
Voltage:
Battery positive voltage.
Repair SRS warning light circuit.
5
Does SRS warning light come on?
C
OK
P
1.
Disconnect negative (–) terminal cable from bat-
tery.
2.
Connect center airbag sensor assembly.
3.
Connect negative (–) terminal cable to battery.
4.
Turn ignition switch ACC or ON.
Check operation of SRS warning light.
SRS warning light comes on.
Check terminal LA of center airbag sensor assembly and
electrical connection check mechanism. If normal, re-
place center airbag sensor assembly.
From the results of the above inspection, the malfunctioning part can now be considered normal. To
make sure of this, use the simulation method to check.
6
Is new ECU–B fuse burnt out again?
Using simulation method, reproduce malfunction symp-
toms (See page
).
Check harness between ECU–B fuse and SRS warning light, and ECU–B fuse and center airbag sensor
assembly.
RS–106
–
SUPPLEMENTAL RESTRAINT SYSTEM
TROUBLESHOOTING
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст