Nissan Murano Z51. Instruction — part 1521
WT-22
< BASIC INSPECTION >
INSPECTION AND ADJUSTMENT
INSPECTION AND ADJUSTMENT
TRANSMITTER WAKE UP OPERATION
TRANSMITTER WAKE UP OPERATION : Description
INFOID:0000000005575979
This procedure must be done after replacement of a transmitter, BCM, or rotation of wheels.
TRANSMITTER WAKE UP OPERATION : Special Repair Requirement
INFOID:0000000005575980
1.
TRANSMITTER WAKE-UP PROCEDURE
1.
Turn the ignition switch ON.
2.
Contact the transmitter activation tool (J-45295) (1) to the side of
the tire at the location to the transmitter.
3.
Press and hold the activation tool button while pushing the tool
to the tire surface. (approximately for 5 seconds)
CAUTION:
Perform the wake-up procedure starting from the vehicle
front left wheel, then repeat the procedure in the order of
the front right wheel, rear right wheel, and rear left wheel.
4.
Check that the low tire pressure warning lamp blinks in the pattern shown as per the following. The pattern
indicates that the transmitter wake-up procedure for the wheel is completed.
5.
Check that the turn signal lamps blink twice when the transmitter wake-up procedure for all wheels is com-
pleted.
6.
Check that the low tire pressure warning lamp turns OFF, after the transmitter wake-up procedure is com-
pleted for all wheels and turns OFF.
Is the transmitter wake-up procedure completed?
YES
>> Perform the transmitter ID registration procedure. Refer to
WT-22, "ID REGISTRATION PROCE-
DURE : Special Repair Requirement"
NO
>> Perform trouble diagnosis for the transmitter. Refer to
ID REGISTRATION PROCEDURE
ID REGISTRATION PROCEDURE : Description
INFOID:0000000005575981
This procedure must be done after replacing or rotating wheels, replacing transmitter or BCM.
ID REGISTRATION PROCEDURE : Special Repair Requirement
INFOID:0000000005575982
1.
TRANSMITTER ID REGISTRATION PROCEDURE
With CONSULT-III.
NNEIC0020ZZ
SEIA0762E
INSPECTION AND ADJUSTMENT
WT-23
< BASIC INSPECTION >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
1.
Display the “WORK SUPPORT” screen and select “ID REGIST”.
Is the transmitter activation tool (J-45295) used for the transmitter ID registration procedure?
YES
>> GO TO 2.
NO
>> GO TO 3.
2.
TRANSMITTER ID REGISTRATION PROCEDURE (WITH THE TRANSMITTER ACTIVATION TOOL)
1.
Turn the ignition switch ON.
2.
Select the start button on the “ID REGIST” screen.
3.
Contact the transmitter activation tool (J-45295) (1) to the side of
the tire at the location to the transmitter.
4.
Press and hold the activation tool button while pushing the tool
to the tire surface. (approximately for 5 seconds)
CAUTION:
Perform the ID registration procedure starting from the
vehicle front left wheel, then repeat the procedure in the
order of the front right wheel, rear right wheel, and rear left
wheel.
5.
When ID registration is completed, check the following pattern at each wheel.
6.
After the ID registration procedure for all wheels is completed, press “END” to end ID registration, and
check that ID registration for all wheels is completed.
Is the check result normal?
YES
>> ID registration END.
NO
>> Performs trouble-diagnosis of the Tire Pressure Monitoring System (TPMS). Refer to
PRESSURE MONITOR : Diagnosis Description"
.
3.
TRANSMITTER ID REGISTRATION PROCEDURE (WITHOUT THE TRANSMITTER ACTIVATION TOOL)
1.
Adjust the tire pressure for all wheels to match the list below.
2.
Drive the vehicle at a speed at more than 40 km/h (25 MPH) for 3 minutes or more, then perform the
transmitter ID registration procedure.
3.
After ID registration for all wheels is completed, press “END” to end ID registration.
4.
Adjust the tire pressures for all wheels to the specified value. Refer to
.
NNEIC0020ZZ
Se-
quence
ID registration position
Turn signal lamp
CONSULT-III
1
Front left wheel
2 blinks
“Red”
↓
“Green”
2
Front right wheel
3
Rear right wheel
4
Rear left wheel
Tire position
Tire pressure kPa (kg/cm
2
, psi)
Front LH
240 (2.4, 35)
Front RH
220 (2.2, 31)
Rear RH
200 (2.0, 29)
Rear LH
180 (1.8, 26)
ID registration position
CONSULT-III
Front LH
“Red”
↓
“Green”
Front RH
Rear RH
Rear LH
WT-24
< BASIC INSPECTION >
INSPECTION AND ADJUSTMENT
Is ID registrations for all wheels completed?
YES
>> ID registration END.
NO
>> Performs trouble-diagnosis of the Tire Pressure Monitoring System (TPMS). Refer to
PRESSURE MONITOR : Diagnosis Description"
.
C1704, C1705, C1706, C1707 LOW TIRE PRESSURE
WT-25
< DTC/CIRCUIT DIAGNOSIS >
C
D
F
G
H
I
J
K
L
M
A
B
WT
N
O
P
DTC/CIRCUIT DIAGNOSIS
C1704, C1705, C1706, C1707 LOW TIRE PRESSURE
Description
INFOID:0000000005575983
When the tire pressure monitoring system detects low inflation pressure, the low tire pressure warning lamps
in the combination meter comes on.
DTC Logic
INFOID:0000000005575984
DTC DETECTION LOGIC
NOTE:
182.7 kPa (1.9 kg/cm
2
, 26 psi): Standard air pressure is for 230 kPa (2.3 kg/cm
2
,33 psi) vehicles.
DTC CONFIRMATION PROCEDURE
1.
DTC REPRODUCTION PROCEDURE
With CONSULT-III
1.
Turn the ignition switch ON.
CAUTION:
Never start the engine.
2.
Check the tire pressure for all wheels and adjust to the specified value. Refer to
.
3.
Perform “SELF-DIAG RESULTS” in “AIR PRESSURE MONITOR” of “BCM”.
Is DTC “C1704”, “C1705”, “C1706”, “C1707” detected?
YES
>> Perform trouble diagnosis. Refer to
NO
>> INSPECTION END
Diagnosis Procedure
INFOID:0000000005575985
1.
CHECK TIRE PRESSURE
Check the internal pressure of all wheels. Refer to
.
Is the inspection result normal?
YES
>> Replace the DTC-detected malfunctioning transmitter. Refer to
NO
>> After adjusting the air pressure, GO TO 2.
2.
CHECK TIRE PRESSURE SIGNAL
With CONSULT-III
1.
Drive for 3 minutes at a speed of 40 km/h (25 MPH) or more, then drive normally for 10 minutes.
2.
Perform “DATA MONITOR” in “AIR PRESSURE MONITOR” of “BCM”.
3.
Select “BCM” in “DATA MONITOR”, and check that the tire pressures match the standard value.
DTC
Display item
Malfunction detected condition
Possible cause
C1704
LOW PRESSURE FL
Front LH tire pressure drops to * kPa (* kg/cm
2
, * psi) or less. [NOTE]
• Low tire pressure
• Transmitter mal-
function
C1705
LOW PRESSURE FR
Front RH tire pressure drops to * kPa (* kg/cm
2
, * psi) or less. [NOTE]
C1706
LOW PRESSURE RR
Rear RH tire pressure drops to * kPa (* kg/cm
2
, * psi) or less. [NOTE]
C1707
LOW PRESSURE RL
Rear LH tire pressure drops to * kPa (* kg/cm
2
, * psi) or less. [NOTE]
Monitor item
Condition
Displayed value
AIR PRESS FL
Drive for 3 minutes at a speed of 40 km/h (25 MPH) or
more, then drive normally for 10 minutes.
Internal pressure of tires
AIR PRESS FR
AIR PRESS RR
AIR PRESS RL
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст