Nissan Sentra. Instruction — part 18
AV-64
< REMOVAL AND INSTALLATION >
[BASE AUDIO]
ANTENNA FEEDER
• When measuring continuity, wrap tin foil around the top of
probe. Then, press the foil against the wire with your finger.
2. If an element is broken, no continuity will exist.
3. To locate a break, move probe along element. Tester indication
will change abruptly when probe passes the broken point.
REPAIR EQUIPMENT
• Conductive silver composition (DuPont No. 4817 or equivalent)
• Ruler 30 cm (11.8 in) long
• Drawing pen
• Heat gun
• Alcohol
• Cloth
REPAIRING PROCEDURE
SEL122R
SEL252I
SEL253I
AV
ANTENNA FEEDER
AV-65
< REMOVAL AND INSTALLATION >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
1. Wipe broken heat wire and its surrounding area clean with a
cloth dampened in alcohol.
2. Apply a small amount of conductive silver composition to tip of
drawing pen.
Shake silver composition container before use.
3. Place ruler on glass along broken line. Deposit conductive silver
composition on break with drawing pen. Slightly overlap existing
heat wire on both sides [preferably 5 mm (0.20 in)] of the break.
4. After repair has been completed, check repaired wire for conti-
nuity. This check should be conducted 10 minutes after silver
composition is deposited.
Do not touch repaired area while test is being conducted.
5. Apply a constant stream of hot air directly to the repaired area
for approximately 20 minutes with a heat gun. A minimum dis-
tance of 3 cm (1.2 in) should be kept between repaired area and
hot air outlet.
If a heat gun is not available, let the repaired area dry for 24
hours.
PIIA0215E
SEL012D
SEL013D
AV-66
< REMOVAL AND INSTALLATION >
[BASE AUDIO]
ANTENNA AMP.
ANTENNA AMP.
Removal and Installation
INFOID:0000000009758830
REMOVAL
1. Remove the rear pillar finisher (RH). Refer to
INT-29, "REAR PILLAR FINISHER : Removal and Installa-
2. Disconnect the antenna amp. harness connector (A) from the
rear window glass.
3. Disconnect the harness connector (C) from the antenna amp.
(1).
4. Remove the antenna amp. screw (B) and the antenna amp. (1).
INSTALLATION
Installation is in the reverse order of removal.
ALNIA1410ZZ
AV
WINDOW ANTENNA
AV-67
< REMOVAL AND INSTALLATION >
[BASE AUDIO]
C
D
E
F
G
H
I
J
K
L
M
B
A
O
P
WINDOW ANTENNA
Removal and Installation
INFOID:0000000010296640
The window antenna is serviced as an assembly with the filament. Refer to
DEF-47, "Inspection and Repair"
.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст