Nissan Qashqai (2007-2010). Manual — part 1223
![](/vehicle/qul/ene/roryboritele/ther.png)
SEC-92
< ECU DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
BCM (BODY CONTROL MODULE)
JCKWA0313GB
![](/vehicle/qul/ene/roryboritele/ree.png)
BCM (BODY CONTROL MODULE)
SEC-93
< ECU DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
JCKWA0314GB
![](/vehicle/qul/ene/roryboritele/fely.png)
SEC-94
< ECU DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
BCM (BODY CONTROL MODULE)
Fail Safe
INFOID:0000000001102185
Fail-safe index
BCM performs fail-safe control when any DTC listed below is detected.
JCKWA0315GB
![](/vehicle/qul/ene/roryboritele/gonu.png)
BCM (BODY CONTROL MODULE)
SEC-95
< ECU DIAGNOSIS >
[WITH INTELLIGENT KEY SYSTEM]
C
D
E
F
G
H
I
J
L
M
A
B
SEC
N
O
P
REAR WIPER CONTROL
BCM detects a rear wiper stopping position according to a rear wiper auto stop signal.
When a rear wiper auto stop signal is in the condition listed below, BCM stops power supply to rear wiper after
rear wiper is activated for five seconds.
NOTE:
The above operation is repeated when operating the rear wiper switch one minute after the stop of the rear
wiper caused by Fail-safe.
TURN SIGNAL LAMP CONTROL
BCM detects the turn signal lamp circuit status from the terminal voltage.
BCM increases the turn signal lamp blinking speed if the bulb or harness open is detected with the turn signal
lamp operating.
NOTE:
The blinking speed is normal while activating the hazard warning lamp.
LIGHT & RAIN SENSOR MALFUNCTION DETECTION FUNCTION
BCM controls the following items when LIGHT & RAIN sensor has a malfunction.
Auto Light Control
Headlamp is turned ON.
Front Wiper Control
The condition just before the activation of Fail-safe is maintained until the front wiper switch is turned OFF.
DTC Inspection Priority Chart
INFOID:0000000001102186
Display contents of CONSULT
Fail-safe
Cancellation
B2190: NATS ANTENNA AMP
• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel cut (ECM)
Erase DTC
B2191: DIFFERENCE OF KEY
• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel cut (ECM)
Erase DTC
B2192: ID DISCORD BCM-ECM
Fuel cut (ECM)
Erase DTC
B2193: CHAIN OF BCM-ECM
Fuel cut (ECM)
Erase DTC
B2194: DISCORD BCM-I-KEY
• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel cut (ECM)
Erase DTC
B2195: ANTI SCANNING
• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel cut (ECM)
Erase DTC
B2196: DONGLE NG
• Inhibits engine cranking
• Inhibits steering lock unlocking (Intelligent Key unit)
• Fuel cut (ECM)
Erase DTC
Ignition switch
Rear wiper switch
Auto stop signal
ON
OFF
Rear wiper stop position signal cannot be
input 5 seconds.
ON
The signal does not change for 5 seconds.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст