Nissan Qashqai (2007-2010). Manual — part 1113
FRONT DOOR LOCK
DLK-531
< ON-VEHICLE REPAIR >
[WITH I-KEY & SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
7.
Reach in to separate the key cylinder rod connection (on the handle).
8.
Disconnect the door key cylinder switch harness connector.
9.
Remove the key cylinder lever from the door key cylinder.
10. While pulling the outside handle, remove the door key cylinder
assembly.
11. Disconnect the front door request switch harness connector (models with Intelligent Key system).
12. While pulling the outside handle, slide toward rear of vehicle to
remove the outside handle.
13. Remove the front gasket and rear gasket.
14. While pulling the outside handle bracket, slide toward rear of
vehicle to remove the outside handle bracket.
PIIB5809E
PIIB5810E
PIIB5811E
PIIB5814E
DLK-532
< ON-VEHICLE REPAIR >
[WITH I-KEY & SUPER LOCK]
FRONT DOOR LOCK
15. Reach in to separate the outside handle cable connection.
INSTALLATION
Install in the reverse order of removal.
CAUTION:
• To install each rod, rotate the rod holder until a click is felt.
• Check the door lock/unlock operation after installation.
• Check the door open/close operation after installation.
PIIB5815E
REAR DOOR LOCK
DLK-533
< ON-VEHICLE REPAIR >
[WITH I-KEY & SUPER LOCK]
C
D
E
F
G
H
I
J
L
M
A
B
DLK
N
O
P
REAR DOOR LOCK
DOOR LOCK
DOOR LOCK : Exploded View
INFOID:0000000001098551
DOOR LOCK : Removal and Installation
INFOID:0000000001098552
REMOVAL
1.
Remove the rear door finisher. Refer to
INT-13, "REAR DOOR FINISHER : Removal and Installation"
.
2.
Fully close the front door window.
3.
Remove the door sealing screen.
4.
Remove the inside handle mounting bolt, and then disconnect the inside handle knob cable and the lock
knob cable.
5.
Remove the door side grommet, and remove the door key cylin-
der assembly (driver side) and the outside handle escutcheon
(passenger side) mounting bolts from the grommet hole.
CAUTION:
Do not forcibly remove the bolts (TORX: T10).
1.
Outside handle
2.
Outside handle escutcheon
3.
Front gasket
4.
Rear gasket
5.
Outside handle bracket
6.
Inside handle
7.
Door lock assembly
Refer to
JMKIA0189GB
JMKIA0020ZZ
DLK-534
< ON-VEHICLE REPAIR >
[WITH I-KEY & SUPER LOCK]
REAR DOOR LOCK
6.
While pulling the outside handle, remove the door key cylinder
assembly.
7.
While pulling the outside handle, slide toward rear of vehicle to
remove the outside handle.
8.
Remove the front gasket and the rear gasket.
9.
Remove the door lock assembly mounting bolts (TORX: T30).
10. Disconnect the door lock actuator connector, and then remove
the door lock assembly.
11. While pulling the outside handle bracket, slide toward rear of
vehicle to remove the outside handle bracket.
PIIB5809E
PIIB5810E
PIIB5811E
MIIB0633E
PIIB5814E
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст