Subaru Forester (2002 year). Service manual — part 6
EXTERIOR/INTERIOR TRIM
EI
Page
1.
General Description. . . . . . . . . . . . . . . . . . . . . .2
2.
Front Grille
3.
Front Under Cover
4.
Front Bumper
5.
Rear Bumper . . . . . . . . . . . . . . . . . . . . . . . ...4
6.
Mud Guard
7.
Protector
8.
Cowl Panel
9.
Front Door Trim
10.
Rear Door Trim
11.
Glove Box
12.
Roof Rail
13.
Console Box
14.
Instrument Panel Assembly
15.
Upper Inner Trim
16.
Lower Inner Trim
17.
Rear Quarter Trim
18.
Sun Visor
19.
Roof Trim
20.
Rear Gate Trim
21.
Floor Mat
22.
Luggage Floor Mat
1. General Description
S911001
A: COMPONENT
S911001A05
2. REAR BUMPER
S911001A0511
쐌
Vehicle without option code “KS”
✩
S5M0392A
(1)
Bumper beam
(2)
Cushion
(3)
Lower center bracket
(4)
Rear bumper plate
(5)
Lower bracket
(6)
Side upper bracket
(7)
Bumper face
(8)
Bumper side plate
Tightening torque: N·m (kgf-m, ft-lb)
T:
93 (9.5, 69)
✩
: For option code, refer to ID section. <Ref. to ID-3, MODEL NUMBER PLATE, IDENTIFICATION, Identification.>
EI-2
GENERAL DESCRIPTION
Exterior/Interior Trim
쐌
Vehicle with option code “KS”
✩
S5M0392A
(1)
Bumper beam
(2)
Cushion
(3)
Lower center bracket
(4)
Rear bumper plate
(5)
Lower bracket
(6)
Side upper bracket
(7)
Bumper face
(8)
Bumper side plate
Tightening torque: N·m (kgf-m, ft-lb)
T:
93 (9.5, 69)
✩
: For option code, refer to ID section. <Ref. to ID-3, MODEL NUMBER PLATE, IDENTIFICATION, Identification.>
EI-3
GENERAL DESCRIPTION
Exterior/Interior Trim
5. Rear Bumper
S911370
A: REMOVAL
S911370A18
CAUTION:
쐌
Handle bumper carefully to avoid damage to
bumper face.
쐌
Do not damage body during removal or
installation of bumper.
쐌
To avoid damage to bumper, lay removed
bumper on sheet spread on the floor. Do not lay
it directly on the floor.
1) Disconnect the ground cable from the battery.
2) Open rear gate.
3) Remove the five screws and the clip from the
rear bumper.
S5M0399
4) Disconnect license plate light and rear fog light
(if equipped) connectors.
5) Remove bolts and clips from under side of
bumper.
S5M0157
6) Remove bumper face and E/A foam.
7) Remove the canister. (with OBD model) <Ref.
to EC(DOHC TURBO)-6, REMOVAL, Canister.>
and <Ref. to EC(SOHC)-7, REMOVAL, Canister.>
8) Remove bolts from bumper stay.
G5M0161
9) Remove rear bumper beam.
EI-4
REAR BUMPER
Exterior/Interior Trim
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст