Subaru Impreza 3 / Impreza WRX / Impreza WRX STI. Service manual — part 419
6MT-13
General Description
MANUAL TRANSMISSION AND DIFFERENTIAL
11.TRANSMISSION MOUNTING
(1)
Pitching stopper
(7)
Upper cushion rubber
Tightening torque: N·m (kgf-m, ft-lb)
(2)
Spacer
(8)
Center crossmember
T1: 35 (3.6, 25.8)
(3)
Lower cushion rubber
(9)
Rear plate
T2: 50 (5.1, 36.9)
(4)
Front plate
(10) Front crossmember
T3: 58 (5.9, 42.8)
(5)
Transmission cushion rubber
(11) Rear cushion rubber
T4: 70 (7.1, 51.6)
(6)
Rear crossmember
T5: 140 (14.3, 103.3)
(1)
T3
T4
T4
T4
T1
T5
T1
T2
(2)
(4)
(5)
(11)
(8)
(7)
(3)
(2)
(9)
(6)
(3)
(10)
MT-01937
6MT-14
General Description
MANUAL TRANSMISSION AND DIFFERENTIAL
C: CAUTION
• Wear appropriate work clothing, including a cap, protective goggles and protective shoes when performing
any work.
• Remove contamination including dirt and corrosion before removal, installation or disassembly.
• Keep the disassembled parts in order and protect them from dust and dirt.
• Before removal, installation or disassembly, be sure to clarify the failure. Avoid unnecessary removal, in-
stallation, disassembly and replacement.
• When disassembling the case and other light alloy parts, disassemble by using a plastic hammer. Do not
pry apart with screwdrivers or other tools.
• Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
• Use SUBARU genuine transmission gear oil, grease or equivalent. Do not mix transmission gear oil,
grease etc. of different grades or manufacturers.
• Be sure to tighten fasteners including bolts and nuts to the specified torque.
• Place shop jacks or rigid racks at the specified points.
• Apply transmission gear oil onto sliding or revolving surfaces before installation.
• Always replace deformed or damaged snap rings.
• Before installing O-rings or oil seals, apply sufficient amount of transmission gear oil to avoid damage and
deformation.
• Be careful not to incorrectly install or fail to install O-rings, snap rings and other such parts.
• Before securing a part on a vise, place cushioning materials such as wood blocks, aluminum plates, or
waste cloth between the part and the vise.
• Avoid damaging the mating surface of the case.
• Before applying liquid gasket, completely remove the old liquid gasket.
D: PREPARATION TOOL
1. SPECIAL TOOL
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
398791700
REMOVER
Used for removing and installing the straight pin
(6 mm).
399527700
PULLER SET
Used for removing and installing the roller bear-
ing (differential).
(1) BOLT (899521412)
(2) PULLER (399527702)
(3) HOLDER (399527703)
(4) ADAPTER (398497701)
(5) BOLT (899520107)
(6) NUT (021008000)
ST-398791700
ST-399527700
(1)
(2)
(3)
(4)
(5)
(6)
6MT-15
General Description
MANUAL TRANSMISSION AND DIFFERENTIAL
498515700
REMOVER
Used for removing the roller bearing of the trans-
fer driven gear.
498247001
MAGNET BASE
• Used for measuring the backlash between
hypoid gears.
• Used with DIAL GAUGE (498247100).
498247100
DIAL GAUGE
• Used for measuring the backlash between
hypoid gears.
• Used with MAGNET BASE (498247001).
498077000
REMOVER
Used for removing the differential taper roller
bearing.
899858600
REMOVER
Used for removing the roller bearing.
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
ST-498515700
ST-498247001
ST-498247100
ST-498077000
ST-899858600
6MT-16
General Description
MANUAL TRANSMISSION AND DIFFERENTIAL
499757002
INSTALLER
Used for installing the bearing cone of transfer
driven gear (transmission case side).
18630AA010
WRENCH COMPL
RETAINER
• Used for removing and installing the differen-
tial side retainer RH.
• WRENCH ASSY (499787000) can also be
used.
499877000
RACE 4-5
INSTALLER
Used for disassembling the driven shaft and
transfer driven gear.
899864100
REMOVER
Used for removing the transmission main shaft
and drive pinion parts.
498057300
INSTALLER
Used for installing the extension oil seal.
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
ST-499757002
ST18630AA010
ST-499877000
ST-899864100
ST-498057300
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст