Subaru Legacy (2005 year). Service manual — part 1003
EI-69
EXTERIOR/INTERIOR TRIM
Rear Gate Trim
30.Rear Gate Trim
A: REMOVAL
1) Remove the clips (A), and remove the rear gate
pillar trim.
2) Remove the clips, and detach the rear gate up-
per trim.
3) Remove the cover in the inner handle, and loos-
en the inside screw.
4) Turn over the weather strip, and remove the
clips.
5) Remove the clips (A), and remove the rear gate
lower trim.
6) Remove the rear gate weather strip.
NOTE:
If the weather strip clip is removed with excessive
force, the weather strip may be damaged. Be sure
to use a clip remover to remove.
B: INSTALLATION
Install in the reverse order of removal.
EI-00670
:(A)
EI-00671
EI-00674
EI-01066
(A)
(A)
EI-00673
EB-00141
EI-70
EXTERIOR/INTERIOR TRIM
Rear Shelf Trim
31.Rear Shelf Trim
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear quarter trim. <Ref. to EI-63,
SEDAN MODEL (MODEL WITH CURTAIN AIR-
BAG), REMOVAL, Rear Quarter Trim.>
3) Remove the high-mounted stop light. <Ref. to LI-
33, REMOVAL, High-mounted Stop Light.>
4) Remove the rear seat cushion. <Ref. to SE-14,
WAGON MODEL, REMOVAL, Rear Seat.>
5) Remove the lower anchor bolt of rear center seat
belt.
6) Disconnect the high-mounted stop light harness
connector (A), remove the five clips, and then re-
move the rear shelf trim with pulling it frontward.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Securely insert the vehicle body panel into the hook
of rear shelf trim center to install the rear shelf trim.
EI-00675
(A)
EI-00676
(1) Hook
(2) Rear shelf trim
(3) Vehicle body panel
(3)
(1)
EI-00739
(2)
EI-71
EXTERIOR/INTERIOR TRIM
Trunk Room Trim
32.Trunk Room Trim
A: REMOVAL
1. TRUNK LID TRIM
1) Remove the trim clips and stopper rubbers, and
remove the trunk lid trim.
2) Remove the clip (A) of trunk side trim, and then
remove the trunk lid arm cover.
2. TRUNK ROOM TRIM
1) Remove the trunk room mat.
2) Remove the trim clips (A), and remove the trunk
room end cover.
3) Remove the rear seat backrest, and then re-
move the trim clips at the front side of trunk side
trim. <Ref. to SE-14, WAGON MODEL, REMOV-
AL, Rear Seat.>
4) Insert a flat tip screwdriver from the lower side of
trunk hook, and then remove the trunk hook with ro-
tating it 90
°.
EI-00628
EI-00629
(A)
EI-00623
(B) Clip
EI-00624
(A)
:(B)
EI-00625
EI-00841
EI-72
EXTERIOR/INTERIOR TRIM
Trunk Room Trim
5) Remove the trim clips, and remove the trunk
side trim.
B: INSTALLATION
1. TRUNK LID TRIM
Install in the reverse order of removal.
2. TRUNK ROOM TRIM
Install in the reverse order of removal.
EI-00626
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст