Subaru Legacy (2005 year). Service manual — part 87
CO(H4SO 2.0)-23
COOLING
Radiator
CAUTION:
• Engine should be turned off.
• Wipe engine coolant from check points in ad-
vance.
• Be careful to prevent engine coolant from
spurting out when removing tester.
• Be careful not to deform the filler neck of ra-
diator when installing or removing the tester.
CO(H4SO 2.0)-24
COOLING
Radiator Cap
7. Radiator Cap
A: INSPECTION
1) Attach the radiator cap to tester.
2) Increase pressure until the tester gauge pointer
stops. Radiator cap is functioning properly if it holds
the service limit pressure for five to six seconds.
Specified pressure:
93 — 123 kPa (0.95 — 1.25 kgf/cm
2
, 14 — 18
psi)
Service limit pressure:
83 kPa (0.85 kgf/cm
2
, 12 psi)
CAUTION:
Be sure to remove foreign matter and rust from
the cap in advance, otherwise results of pres-
sure test will be incorrect.
CO-00044
CO(H4SO 2.0)-25
COOLING
Radiator Main Fan and Fan Motor
8. Radiator Main Fan and Fan
Motor
A: REMOVAL
1) Set the vehicle on a lift.
2) Disconnect the ground cable from battery.
3) Lift-up the vehicle.
4) Remove the under cover.
5) Disconnect the connector (A) of main fan motor.
6) Remove the heat shield cover. (Model without
ATF warmer)
7) Remove the ATF hose from the clip of radiator
main fan motor assembly. (Model without ATF
warmer)
8) Lower the vehicle.
9) Disconnect the over flow hose.
10) Remove the reservoir tank. <Ref. to CO(H4SO
2.0)-29, REMOVAL, Reservoir Tank.>
11) Remove the bolts which hold the radiator main
fan shroud to radiator.
12) Remove the radiator main fan motor assembly.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
When the radiator main fan motor assembly cannot
be installed, loosen the bolts which secure radiator
sub fan motor assembly.
Tightening torque:
7.5 N
⋅
m (0.76 kgf-m, 5.5 ft-lb)
C: DISASSEMBLY
1) Remove the clip which holds motor connector
onto the shroud.
2) Remove the nut which holds the fan onto fan
motor and shroud.
IN-00203
CO-00274
(A)
CO-00273
CO-00096
CO-00096
CO-00102
CO(H4SO 2.0)-26
COOLING
Radiator Main Fan and Fan Motor
3) Remove the bolts which install fan motor onto
the shroud.
D: ASSEMBLY
Assemble in the reverse order of disassembly.
Tightening torque:
5 N
⋅
m (0.5 kgf-m, 3.7 ft-lb)
Tightening torque:
3.4 N
⋅
m (0.35 kgf-m, 2.5 ft-lb)
CO-00098
CO-00098
CO-00102
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст