Subaru Legacy (2005 year). Service manual — part 892
AB(diag)-5
AIRBAG SYSTEM (DIAGNOSTICS)
General Description
• If any damage, opening or rust is found on the
airbag system wire harness, do not attempt to re-
pair using soldering equipment. Replace the faulty
harness with a new genuine part.
• Install the wire harness securely with the speci-
fied clips to avoid interference or tangled up with
other parts.
• Do not allow water or oil to come in contact with
the connector terminals. Also do not touch the con-
nector terminals.
• Either of the airbag modules for driver’s side,
passenger’s, side and curtain or pretensioner must
not be disassembled.
• The airbag module cannot be used again if de-
ployed once.
• After removal, keep the airbag module with the
pad facing upward on a dry, clean and flat surface
away from heat, light sources, moisture and dust.
• Do not check continuity of the airbag modules for
driver’s side, passenger’s side and curtain, or pre-
tensioner.
AB-00124
AB-00125
AB-00126
AB-00127
AB-00056
AB-00006
AB(diag)-6
AIRBAG SYSTEM (DIAGNOSTICS)
General Description
• The removed front seat with an airbag module
must be kept at least 200 mm (8 in) away from walls
and other objects.
• When painting or repairing work for sheet metal
on the front part of the vehicle including the front
wheel apron, front fender and front side frame, re-
move the front sub sensors, curtain airbag sensor
and wire harness of the airbag system.
• When painting or performing sheet metal work
on the side of the vehicle, including the side sill,
center pillar and front and rear doors, remove the
side airbag sensors and wire harness of the airbag
system.
• Do not discard undeployed airbag module. They
could cause a serious accident if accidentally de-
ployed.
(1) 200 mm (8 in) or more
AB-00128
(1)
AB-00129
AB(diag)-7
AIRBAG SYSTEM (DIAGNOSTICS)
General Description
• When storing the removed airbag module, do not place any objects on it or pile them up. If the airbag de-
ploys for some reason when it is placed with the pad side facing downward or under any object, a serious ac-
cident may result.
(1)
Driver’s airbag module
(2)
Passenger’s airbag module
AB-00130
(2)
(1)
AB(diag)-8
AIRBAG SYSTEM (DIAGNOSTICS)
General Description
B: INSPECTION
Measure the battery voltage and check electrolyte.
Standard voltage: 12 V
Specific gravity: Above 1.260
C: PREPARATION TOOL
CAUTION:
To measure the voltage and resistance of airbag system component, be sure to use the specified test
harness.
1. SPECIAL TOOL
• TEST HARNESS F
ILLUSTRATION
TOOL NUMBER
DESCRIPTION
REMARKS
98299FC010
TEST HARNESS F
Used when measuring voltage and resistance of
side airbag module and curtain airbag module.
3F
2F
1F
ST98299FC010
AB-00927
3F
3F
2F
1F
2F
1F
4
3
6
5
1
1
2
2
1
3 4 5 6
2
1 2
2 1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст