Subaru Legacy IV (2008 year). Service manual — part 6
NT-4
Note
NOTE
(A)
Front
(B)
Rear
(1)
Front crossmember
(2)
Rear differential
NT-00170
(1)
(2)
(A)
(B)
NT-5
Note
NOTE
8. TIE-DOWNS
Tie-downs are used when transporting vehicles and when using the chassis dynamo. Attach tie-down only
to the specified locations on the vehicle.
• TIE-DOWN LOCATION
CAUTION:
Use the T-hook for rear tie-down. Do not use the hook other than T-hook, otherwise it can be removed
when transporting vehicles.
• CHAIN DIRECTION AT TIE-DOWN CONDITION
NOTE:
Pull the chains LH and RH in the same direction,
but front and rear side in the counter direction. Pull
all the chains in a same moment.
(1)
Hook for tie-down
(1)
(1)
(1)
NT-00149
NT-00117
NT-6
Note
NOTE
• CHAIN PULLING RANGE AT TIE-DOWN
CONDITION
• VEHICLE SINKING VOLUME AT TIE-DOWN
CONDITION
Measure the distance between the highest tire
point and highest arch point before and after tie-
down. Difference of measured values (sinking vol-
ume) should be within 50 mm (1.97 in) and make
sure to fix the vehicle securely.
(1) Chain pulling range at tie-down condition
(2) 20°
(3) 45°
(F) Front side
(1) Tightening direction of chain
(2) 45°
NT-00122
(2)
(2)
(2)
(2)
(3)
(3)
(3)
(3)
: (1)
(2)
(2)
NT-00151
(1)
(1)
(2)
(2)
F
NT-00076
L
L
NT-7
Note
NOTE
9. TOWING
Avoid towing vehicles except when the vehicle cannot be driven. For models with AWD, AT or VTD, use a
loader instead of towing. When towing other vehicles, pay attention to the following to prevent hook or vehicle
damage resulting from excessive weight.
• Do not tow other vehicles with a front tie-down hook.
• Make sure the vehicle towing is heavier than the vehicle being towed.
• Front
Remove the fog light cover (except for OUTBACK model) and hook cover, and then install the hook.
• Rear
(A)
Fog light cover
(except for OUTBACK model)
(B)
Hook cover
(C)
Hook
(A)
(C)
(B)
(C)
(B)
NT-00171
NT-00078
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст