Subaru Legacy IV (2008 year). Service manual — part 1041
SB-2
General Description
SEAT BELT SYSTEM
1. General Description
A: COMPONENT
1. FRONT SEAT BELT
(1)
Adjustable anchor ASSY
(5)
Center pillar upper trim
Tightening torque:N·m (kgf-m, ft-lb)
(2)
Shoulder anchor
(6)
Inner seat belt ASSY
T1: 7.5 (0.76, 5.5)
(3)
Outer seat belt ASSY
(7)
Belt tension sensor
(Passenger’s side only)
T2: 30 (3.1, 22)
(4)
Seat belt retractor
T3: 38 (3.9, 28)
T4: 53 (5.4, 39)
SB-00345
(6)
T3
T2
T2
T4
(3)
(7)
(4)
(5)
(2)
(1)
T1
T4
SB-3
General Description
SEAT BELT SYSTEM
2. REAR SEAT BELT (SEDAN MODEL)
(1)
Outer seat belt RH ASSY
(4)
Center seat belt LH ASSY
Tightening torque:N·m (kgf-m, ft-lb)
(2)
Shoulder seat belt center ASSY
(5)
Center seat belt RH ASSY
T: 30 (3.1, 22)
(3)
Outer seat belt LH ASSY
T
(4)
(2)
(1)
(3)
T
T
(5)
T
SB-00333
SB-4
General Description
SEAT BELT SYSTEM
3. REAR SEAT BELT (WAGON MODEL)
(1)
Outer seat belt RH ASSY
(5)
Center seat belt LH ASSY
Tightening torque:N·m (kgf-m, ft-lb)
(2)
Shoulder seat belt center ASSY
(6)
Outer belt guide RH
T1: 30 (3.1, 22)
(3)
Outer seat belt LH ASSY
(7)
Outer belt guide LH
T2: 53 (5.4, 39.1)
(4)
Center seat belt RH ASSY
SB-00148
(2)
(6)
(1)
(4)
(7)
T2
(5)
(3)
T1
T1
T1
T1
T1
SB-5
General Description
SEAT BELT SYSTEM
B: CAUTION
• Before starting the work, turn the ignition switch
to OFF, disconnect the battery ground cable and
wait for 20 seconds or more.
• The pretensioner system has a backup power
source. The pretensioner might deploy if you do not
wait for 20 seconds or more before starting work.
• Do not drop or apply any impact to the preten-
sioner.
• If oil, grease or water gets on the pretensioner,
wipe it off immediately with a dry cloth.
• Do not expose the pretensioner to high tempera-
ture or flame.
• Do not allow current to flow through or voltage to
reach the pretensioner. Do not use a circuit tester
to check resistance of the pretensioner.
• Do not disassemble or attempt to repair the pre-
tensioner. If it is dented, cracked or deformed, re-
place it with a new part.
• Do not use the airbag or pretensioner parts from
other vehicles. Always replace parts with new
parts.
• When handling a seat belt with deployed preten-
sioner, wear gloves and goggles. Wash your hands
afterwards.
• Do not reuse a seat belt with deployed preten-
sioner.
• If material from the airbag enters the eyes or con-
tacts skin during deployment, wash it away with
clean water, and then consult a doctor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст