Subaru Legacy III (2000-2003 year). Service manual — part 44
EC(H4SO)-4
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
REAR CATALYTIC CONVERTER
3. Rear Catalytic Converter
A: REMOVAL
The front and rear catalytic converter and center
exhaust pipe are integrated into one unit. There-
fore, the removal procedure is the same as that for
the center exhaust pipe. <Ref. to EX(H4SO)-8, RE-
MOVAL, Center Exhaust Pipe.>
B: INSTALLATION
The front and rear catalytic converter and center
exhaust pipe are integrated into one unit. There-
fore, the installation procedure is the same as that
for the center exhaust pipe. <Ref. to EX(H4SO)-8,
INSTALLATION, Center Exhaust Pipe.>
C: INSPECTION
1) Make sure there are no exhaust leaks from con-
nections and welds.
2) Make sure there are no holes or rusting.
EC(H4SO)-5
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
EGR VALVE
4. EGR Valve
A: REMOVAL
For work procedures, refer to “FU(H4SO)” section.
<Ref. to FU(H4SO)-35, REMOVAL, EGR Valve.>
B: INSTALLATION
For work procedures, refer to “FU(H4SOH4SO)”
section. <Ref. to FU(H4SO)-35, INSTALLATION,
EGR Valve.>
EC(H4SO)-6
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
CANISTER
5. Canister
A: REMOVAL
1) Lift-up the vehicle.
2) Loosen two clamps which hold two canister hos-
es, and disconnect evaporation three hoses from
canister.
3) Remove canister from body.
B: INSTALLATION
1) Install in the reverse order of removal.
Tightening torque:
23 N·m (2.3 kgf-m, 17 ft-lb)
C: INSPECTION
Make sure the canister and canister hoses are not
cracked or loose.
EC-00150
EC-00151
EC-00152
EC(H4SO)-7
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)
PURGE CONTROL SOLENOID VALVE
6. Purge Control Solenoid Valve
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Disconnect the connector and hoses from purge
control solenoid valve, and then remove the purge
control solenoid valve.
B: INSTALLATION
1) Install in the reverse order of removal.
Tightening torque:
19 N·m (1.9 kgf-m, 13.7 ft-lb)
NOTE:
Connect the evaporation hoses as shown in the fig-
ure.
C: INSPECTION
Make sure hoses are not cracked or loose.
FU-00009
EC-00014
(A) To fuel pipe
(B) To intake manifold
EC-00014
FU-00285
A
B
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст