Subaru Legacy III (2000-2003 year). Service manual — part 238
FU(H6DO)-36
FUEL INJECTION (FUEL SYSTEMS)
IDLE AIR CONTROL SOLENOID VALVE
11.Idle Air Control Solenoid
Valve
A: REMOVAL
1) Disconnect battery ground cable.
2) Disconnect connector (A) from idle air control
solenoid valve.
3) Disconnect air by-pass hose (B) from idle air
control solenoid valve.
4) Remove idle air control solenoid valve from
throttle body.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Replace gasket with a new one.
Tightening torque:
2.8 N·m (0.29 kgf-m, 2.1 ft-lb)
FU-00535
FU-00581
( A )
( B )
FU(H6DO)-37
FUEL INJECTION (FUEL SYSTEMS)
INDUCTION VALVE
12.Induction Valve
A: REMOVAL
1) Disconnect battery ground cable.
2) Remove intake manifold.
<Ref. to FU(H6DO)-17, REMOVAL, Intake Mani-
fold.>
3) Remove induction valve from intake manifold.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Always use a new gasket.
Tightening torque:
19 N·m (1.9 kgf-m, 14 ft-lb)
FU-00560
FU(H6DO)-38
FUEL INJECTION (FUEL SYSTEMS)
INDUCTION VALVE CONTROL SOLENOID
13.Induction Valve Control Sole-
noid
A: REMOVAL
1) Disconnect battery ground cable.
2) Remove intake manifold.
<Ref. to FU(H6DO)-17, REMOVAL, Intake Mani-
fold.>
3) Disconnect connector from induction valve con-
trol solenoid.
4) Remove induction valve control solenoid from in-
take manifold.
B: INSTALLATION
Install in the reverse order of removal.
NOTE:
Always use a new gasket.
Tightening torque:
19 N·m (1.9 kgf-m, 14 ft-lb)
FU-00561
FU(H6DO)-39
FUEL INJECTION (FUEL SYSTEMS)
FUEL INJECTOR
14.Fuel Injector
A: REMOVAL
1. RH SIDE
1) Release fuel pressure.
<Ref. to FU(H6DO)-50, RELEASING OF FUEL
PRESSURE, OPERATION, Fuel.>
2) Open fuel flap lid, and remove fuel filler cap.
3) Disconnect battery ground cable.
4) Remove air cleaner lower case. <Ref. to
IN(H6DO)-5, REMOVAL, Air Cleaner.>
5) Remove power steering pump and tank from
brackets.
(1) Remove V-belt.
<Ref. to ME(H6DO)-28, REMOVAL, V-belt.>
(2) Remove power steering oil pipe with brack-
et.
(3) Remove bolts which install power steering
pump bracket.
CAUTION:
Do not separate hose and pipe from the main
pump.
(4) Disconnect power steering pump switch
connector.
(5) Remove power steering tank from the
bracket by pulling it upward.
FU-00009
ME-00449
(A) Power steering pump
(B) Generator
(C) A/C compressor
ME-00482
( A )
( B )
( C )
FU-00541
FU-00429
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст