Subaru Legacy III (2000-2003 year). Service manual — part 390
FU(H4DOSTC)-26
FUEL INJECTION (FUEL SYSTEMS)
INTAKE MANIFOLD
9) Connect the hoses to purge control solenoid
valve.
NOTE:
Connect the evaporation hoses as shown in the fig-
ure.
10) Connect the connector to fuel injector.
11) Install the evaporation and coolant pipe assem-
bly.
12) Connect the evaporation hoses to evaporation
and coolant pipe assembly.
Tightening torque:
5.0 N·m (0.51 kgf-m, 3.7 ft-lb)
13) Install the throttle body to intake manifold.
NOTE:
Replace the gasket with a new one.
Tightening torque:
22 N·m (2.2 kgf-m, 15.9 ft-lb)
14) Connect the connector to the throttle position
sensor (A), idle air control solenoid valve (B) and
pressure sensor (C).
15) Install the engine ground cable to intake mani-
fold.
Tightening torque:
19 N·m (1.94 kgf-m, 13.7 ft-lb)
(A) To intake manifold
(B) To fuel pipe assembly
(A)
(B)
FU-00054
FU-00652
FU-00653
FU-00013
FU-00651
(B)
(A)
(C)
FU-00649
FU(H4DOSTC)-27
FUEL INJECTION (FUEL SYSTEMS)
INTAKE MANIFOLD
16) Connect the engine harness with clip to engine
coolant pipe.
E: INSPECTION
Make sure the fuel pipe and fuel hoses are not
cracked and that connections are tight.
FU-00650
FU(H4DOSTC)-28
FUEL INJECTION (FUEL SYSTEMS)
ENGINE COOLANT TEMPERATURE SENSOR
4. Engine Coolant Temperature
Sensor
A: REMOVAL
1) Drain engine coolant.
2) Disconnect the ground cable from battery.
3) Remove the generator. <Ref. to SC(H4DOSTC)-
14, REMOVAL, Generator.>
4) Disconnect the connector from engine coolant
temperature sensor.
5) Remove the engine coolant temperature sensor.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
18 N·m (1.8 kgf-m, 13.3 ft-lb)
FU-00009
FU-00663
FU(H4DOSTC)-29
FUEL INJECTION (FUEL SYSTEMS)
CRANKSHAFT POSITION SENSOR
5. Crankshaft Position Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bolt which installs crankshaft posi-
tion sensor to cylinder block.
3) Remove the crankshaft position sensor, and
then disconnect the connector from it.
B: INSTALLATION
Install in the reverse order of removal.
Tightening torque:
T: 6.4 N·m (0.65 kgf-m, 4.7 ft-lb)
FU-00009
FU-00056
FU-00057
FU-00058
T
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст