Subaru BRZ (2012 year). Service manual — part 26
PM-33
Fuel Filter
PERIODIC MAINTENANCE SERVICES
10) If the fuel gauge indicates that two thirds or more of the fuel is remaining, drain fuel according to the fol-
lowing procedures. (Method with Subaru Select Monitor)
NOTE:
• If the fuel pump cannot be driven, refer to the procedures for draining from the fuel tank to filler pipe hose.
• Be careful not to let the battery run-out.
(1) Use the ST to disconnect the fuel hoses on the port injection side and on the cylinder internal injector
side.
ST 42099AE000
CAUTION:
• Before performing the procedures, remove any foreign material such as mud adhering to the fuel
hose connection parts.
• Be careful not to spill fuel.
• Catch the fuel from fuel hoses using a container.
(2) Connect the ST to the fuel hose.
ST 18471AA000
(3) Connect the gasoline-proof hose to the ST and put the end of the hose in the container.
(4) Drive the fuel pump and drain the fuel using Subaru Select Monitor.
PM-00736
PM-34
Fuel Filter
PERIODIC MAINTENANCE SERVICES
11) If the fuel gauge indicates that two thirds or more of the fuel is remaining, drain fuel according to the fol-
lowing procedures. (Method for draining from fuel tank to filler pipe hose)
WARNING:
Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.
CAUTION:
• Be careful not to spill fuel.
• Fuel may remain in the fuel filler pipe. Drain the fuel from the fuel filler pipe through the fill opening
using a gasoline-resistant pump and hose (10 mm (0.39 in) or less) before performing the proce-
dures.
(1) Remove the two nuts and two bolts, and disconnect the exhaust tail pipe assembly.
(2) Remove the cushion rubber and the exhaust pipe assembly CTR.
(3) Remove the gasket.
PM-00716
PM-00717
PM-35
Fuel Filter
PERIODIC MAINTENANCE SERVICES
(4) Remove the four cushion rubbers and the exhaust tail pipe assembly.
(5) Loosen the hose clamp, and disconnect the fuel tank to filler pipe hose.
CAUTION:
• Before performing the procedures, remove any foreign material such as mud adhering to the con-
necting parts of the fuel tank to filler pipe hose.
• Be careful not to spill fuel.
(6) Set a steel container under the vehicle and use a gasoline-resistant hose (10 mm (0.39 in) or less) to
drain the fuel from the opening of the fuel tank to filler pipe hose.
CAUTION:
Be careful not to spill fuel.
NOTE:
Always be sure to use a steel container and ground the container as gasoline can easily become charged
with static electricity.
(7) Install the fuel tank to filler pipe hose using hose clamps.
Tightening torque:
2.0 N·m (0.2 kgf-m, 1.5 ft-lb)
12) Disconnect the ground cable from battery.
13) Remove the separator-type rear seat cushion assembly LH.
PM-00718
PM-36
Fuel Filter
PERIODIC MAINTENANCE SERVICES
14) Press in the grommet and remove the grommet from rear floor service hole cover No. 2.
15) Peel off the butyl tape and remove rear floor service hole cover No. 2.
16) Disconnect the fuel pump connector.
PM-00683
PM-00684
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст