Subaru Baja (2006 year). Manual — part 10
3-32
Instruments and controls
V Compass zone adjustment
1. The zone setting is factory preset to Zone 8. Refer
to the “Compass calibration zone” map at the end of
this manual to verify that the compass zone setting is
correct for your geographical location.
2. Press and hold the right button for 3 seconds then
release, and the word “ZONE” will briefly appear and
then the zone number will be displayed.
3. Press the right-hand button repeatedly to cycle the
display through all possible zone settings. Stop cycling
when the correct zone setting for your location is dis-
played.
4. Releasing the button for 3 seconds will exit the
zone setting mode.
Outside mirrors
Outside mirrors
T Convex mirror (Passenger side)
Objects look smaller in a convex mirror and far-
ther away than when viewed in a flat mirror. Do
not use the convex mirror to judge the distance
of vehicles behind you when changing lanes.
Use the inside mirror (or glance backwards) to
determine the actual size and distance of ob-
jects that you view in convex mirror.
T Adjusting mirrors
To adjust the mirrors by hand, push where indicated
by the arrows.
T Remote control mirror switch
The remote control mirrors operate only when the ig-
nition switch is in the “ON” or “ACC” position.
OM-U2737
3-33
Instruments and controls
– CONTINUED –
1) Selection switch
2) Direction control switch
1. Press either end of the selection switch, “L” for the
left, “R” for the right.
2. Move the direction control switch in the direction
you want to move the mirror.
3. Return the selection switch to the neutral position
to prevent unintentional operation.
The mirrors can also be adjusted manually.
T Outside mirror defogger (if equipped)
To prevent the battery from being discharged,
do not operate the defogger continuously for
any longer than necessary.
The outside mirror defogger operates only when the
ignition switch is in the “ON” or “ACC” position.
1) Indicator light
To turn on the outside mirror defogger, push the but-
ton while the engine is running.
1
2
UB4004BB
1
UB4004CB
3-34
Instruments and controls
The indicator light located on the button will come on
when the outside mirror defogger heater in operation.
To turn it off, push the button again.
Tilt steering wheel
Tilt steering wheel
Do not adjust the steering wheel tilt position
while driving. This may cause loss of vehicle
control and result in personal injury.
1. Adjust the seat position. Refer to the “Front seats”
section (chapter 1).
2. Pull the tilt lock lever down.
3. Move the steering wheel to the desired level.
4. Push the lever up to lock the steering wheel in
HS3043BA
3-35
Instruments and controls
– CONTINUED –
place.
5. Make sure that the steering wheel is securely
locked by moving it up and down.
Horn
Horn
To sound the horn, push the horn pad.
HS3044BA
4-1
4
Ventilator . . . . . . . . . . . . . ...
Driver’s side ventilators . . . . . . . . ...
Center ventilators . . . . . . . . . . . .
Front passenger’s side ventilators . . . . .
Air flow selection . . . . . . . . . . . ..
Manual heating and air conditioning
system . . . . . . . . . . . . . .
Control panel . . . . . . . . . . . . . .
Heater operation . . . . . . . . . . . ...
Air conditioner operation . . . . . . . . .
Operating tips for heater and air
conditioner . . . . . . . . . . . . .
4-2
Climate control
Climate control
Ventilator
Driver’s side ventilators
1) Open
2) Close
Move the thumb-wheel up and down or right and left to
adjust the flow direction.
Center ventilators
Move the thumb-wheel up and down or right and left to
adjust the flow direction.
1
2
UB4038BB
UB4039BA
4-3
Climate control
– CONTINUED –
Front passenger’s side ventilators
1) Open
2) Close
Move the thumb-wheel up and down or right and left to
adjust the flow direction.
1
2
UB4040BB
4-4
Climate control
Air flow selection
UB4036BA
4-5
Climate control
– CONTINUED –
Manual heating and air conditioning
system
Control panel
1) Temperature control dial
2) Fan speed control dial
3) Air flow control dial
4) Air conditioner button
5) Air inlet selection button
6) Rear window defogger button (Refer to “Rear window
defogger button” section in chapter 3.)
T Temperature control dial
This dial regulates the temperature of air flow from the
air outlets over a range from the blue area (cool) to red
area (warm).
T Fan speed control dial
The fan operates only when the ignition switch is
turned to the “ON” position. The fan speed control dial
is used to select four fan speeds.
T Air flow control dial
This dial has the following five positions:
: Air flows through the instrument panel outlets.
: Air flows through the instrument panel outlets
and the foot outlets.
: Air flows through the foot outlets and some
through the windshield defroster outlets.
: Air flows through the windshield defroster outlets
and foot outlets.
: Air flows through the windshield defroster out-
lets.
1
6
5
4
2
3
UB5004BC
4-6
Climate control
NOTE
When the dial is placed in the “
” or “
” po-
sition, the air conditioner compressor operates
automatically regardless of the position of the air
conditioner button to defog the windshield quick-
ly. At the same time, the air inlet selection is auto-
matically set to “Outside air” mode.
In this state, you cannot select “recirculation”
mode by manually pressing the air inlet selection
button.
T Air conditioner button
The air conditioner operates only when the engine is
running.
Push the air conditioner button while the fan is in op-
eration to turn on the air conditioner. The indicator light
will come on.
Push it again to turn off the air conditioner.
T Air inlet selection button
Continued operation in the ON position may fog
up the windows. Switch to the OFF position as
soon as the outside dusty condition clears.
UG4507BA
UB4041BA
4-7
Climate control
– CONTINUED –
ON position (Recirculation): Interior air is recirculat-
ed inside the vehicle. Push the air inlet selection but-
ton to the ON position. The indicator light will come on.
Push the air inlet selection button to the ON position
for fast cooling with the air conditioner or when driving
on a dusty road.
OFF position (Outside Air): Outside air is drawn into
the passenger compartment. Push the air inlet selec-
tion button again to the OFF position. The indicator
light will go off.
Push the air inlet selection button to the OFF position
when the interior has cooled to a comfortable temper-
ature and the road is no longer dusty.
Heater operation
T Defrosting or defogging the windshield
To direct warm air to the windshield and front door win-
dows:
1. Set the air flow control dial to “
”.
2. Turn the temperature control dial all the way to the
right.
3. Set the fan speed control dial to the highest speed.
NOTE
Warm air also comes out from the right and left air
outlets. To stop warm air flow from these outlets,
turn the corresponding thumb-wheel to the
UB5011AA
4-8
Climate control
“
” position.
T Heating and defrosting
To direct warm air toward the floor and the windshield:
1. Set the air flow control dial to “
”.
2. Set the temperature control dial to the desired tem-
perature level.
3. Set the fan speed control dial to the desired speed.
NOTE
Warm air also comes out from the right and left air
outlets. To stop warm air flow from these outlets,
turn the corresponding thumb-wheel to the
“
” position.
T Heating
To direct warm air toward the floor:
1. Set the air inlet selection button to the “OFF” posi-
tion.
2. Set the air flow control dial to “
”.
3. Set the temperature control dial to the desired tem-
perature level.
4. Set the fan speed control dial to the desired speed.
NOTE
Warm air also comes out from the right and left air
outlets. To stop warm air flow from these outlets,
turn the corresponding thumb-wheel to the
“
” position.
UB5012AA
UB5013AA
4-9
Climate control
– CONTINUED –
T Bi-level heating
This setting allows you to direct air of different temper-
atures from the instrument panel and foot outlets. The
air from the foot outlets is slightly warmer than from the
instrument panel outlets.
1. Set the air inlet selection button to the “OFF” posi-
tion.
2. Set the air flow control dial to “
”.
3. Set the temperature control dial to the desired tem-
perature level.
4. Set the fan speed control dial to the desired speed.
Setting the temperature control dial fully turned to the
red area or blue area decreases the temperature dif-
ference between the air from the instrument panel out-
lets and the air from the foot outlets.
T Ventilation
To force outside air through the instrument panel out-
lets:
1. Set the air inlet selection button to the “OFF” posi-
tion.
2. Set the air flow control dial to “
”.
3. Set the temperature control dial all the way left.
4. Set the fan speed control dial to the desired speed.
When driving on a dusty road, set the air inlet control
button to the “ON” position.
UB5014AA
UB5015AA
4-10
Climate control
Continued operation with the air inlet selection
button in the ON position may fog up the win-
dows. Switch to the OFF position as soon as
the outside dusty condition clears.
Air conditioner operation
T Cooling or dehumidifying
1) ON position
For cooling and dehumidification of the passenger
compartment, performing the following steps will allow
air to flow through the instrument panel outlets:
1. Set the air inlet selection button to the “OFF” posi-
tion.
2. Set the air flow control dial to “
”.
3. Set the air conditioner button to the “ON” position.
4. Set the temperature control dial to the blue area.
5. Set the fan speed control dial at the desired speed.
T Defrosting or defogging
1) ON position
To direct warm air to the windshield and front door win-
dows:
1. Set the air outlet control dial to “
”.
1
UB5016BB
1
UB5011BB
4-11
Climate control
– CONTINUED –
2. Set the temperature control dial to the red area.
3. Set the fan speed control dial at the highest speed.
Operating tips for heater and air con-
ditioner
T Cleaning ventilator grille
Always keep the front ventilator inlet grille free of
snow, leaves, or other obstructions to ensure efficient
heating and defrosting. Since the condenser is located
in front of the radiator, this area should be kept clean
because cooling performance is impaired by any ac-
cumulation of insects and leaves on the condenser.
T Efficient cooling after parking in direct sunlight
After parking in direct sunlight, drive with the windows
UB4037BA
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст