Opel Frontera UBS. Service manual — part 1484
7A–178
AUTOMATIC TRANSMISSION (AW30-40LE)
249RY00002
249RY00003
249RY00004
240RY00021
Important operations
1. Spacer
Using a chisel, cut off the spacer and remover it from the
shaft.
2. Pin
Using a punch, drive out the pin.
3. Manual valve lever shaft
4. Manual valve lever
Pull the manual valve lever shaft out through the case by
the threads.
5. Oil seal
6. Oil seal
Using a screwdriver, remove the oil seal.
On–vehicle replacement of oil seal
Using special tool, install the oil seal.
Installer : 5–8840–2169–0 (J–37232–2)
AUTOMATIC TRANSMISSION (AW30-40LE)
7A–179
REASSEMBLY
249RX00001
Reassembly steps
▲
1. Oil seal
▲
2. Oil seal
▲
3. Spacer
▲
4. Manual valve lever
▲
5. Manual valve lever shaft
▲
6. Pin
7A–180
AUTOMATIC TRANSMISSION (AW30-40LE)
240RY00021
249RY00005
249RY00006
249RY00003
Important operations
1. Oil seal
2. Oil seal
Coat a new oil seal lip with multi purpose grease.
Using special tool, drive in the oil seal.
Oil seal installer : 5–8840–2169–0 (J–37232–2)
3. Spacer
4. Manual valve lever
Assemble a new spacer to the manual valve lever.
5. Manual valve lever shaft
Install the manual valve lever shaft to the transmission case
through the manual valve lever by the threads.
6. Pin
Drive in the pin with the slot at a right angle to the shaft.
Match the spacer hole to the lever staking hollow and stake
the spacer to the lever.
Make sure the manual valve lever shaft turns smoothly.
AUTOMATIC TRANSMISSION (AW30-40LE)
7A–181
241RY00018
TORQUE CONVERTER
INSPECTION AND REPAIR
Insert special tool in end of torque converter
Insert a turning tool into the inner race of the one–way
clutch.
One–way clutch testing tool : 5–8840–2168–0 (J–35467)
Insert the stopper so that it fits in the notch of the converter
hub and outer race of the one–way clutch.
Test one–way clutch
The clutch should lock when turned counterclockwise, and
rotate freely and smoothly clockwise. Less than 25kg·cm
(22 Ib·in) of torque should be required to rotate the clutch
clockwise. If necessary, clean the converter and retest the
clutch. Replace the converter if the clutch still fails the test.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст