Opel Frontera UBS. Service manual — part 25
![](/vehicle/goneen/quin/zou/pas.png)
1A – 16 HEATING AND VENTILATION
Removal Steps
1. Blower assembly
2. Lower case
3. Upper case
4. Mode door
5. Sub-lever
6. Door lever
Installation Steps
To install, follow the removal steps in the
reverse order.
BLOWER LINK UNIT AND/OR MODE DOOR
This illustration is based on LHD
1
3
6
2
4
5
![](/vehicle/goneen/quin/zou/urathe.png)
HEATING AND VENTILATION 1A – 17
REMOVAL
Preparation:
Disconnect the battery ground cable
1. Blower Assembly
Refer to “BLOWER ASSEMBLY” removal procedure
in this section.
2. Lower Case
3. Upper Case
Separate upper case and slit the lining parting face
with a knife.
INSTALLATION
To install, follow the removal steps in the reverse order,
noting the following points:
1. Apply grease to the door lever and to the abrasive
surface of the upper case.
2. Apply an adhesive to parting face of lining when
assembling upper case.
![](/vehicle/goneen/quin/zou/xor.png)
3
4
2
1
5
6
1A – 18 HEATING AND VENTILATION
Removal Steps
1. Blower motor connector
2. Attaching screw
3. Blower motor assembly
4. Clip
5. Fan
6. Blower motor
Installation Steps
To install, follow the removal steps in the
reverse order.
BLOWER MOTOR
This illustration is based on LHD
![](/vehicle/goneen/quin/zou/defla.png)
HEATING AND VENTILATION 1A – 19
REMOVAL
Preparation:
Disconnect the battery ground cable
1. Blower Motor Connector
2. Attaching Screw
3. Blower Motor Assembly
4. Clip
5. Fan
6. Blower Motor
INSTALLATION
To install, follow the removal steps in the reverse order.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст