Opel Frontera UBS. Service manual — part 837
![](/vehicle/goneen/quin/zou/bee.png)
8I–4
SUN ROOF/CONVERTIBLE TOP
Sun Roof Deflector
Removal
1. Open the sun roof.
2. Remove the fixing screws(2) to remove the sun roof
deflector(1).
665RS006
Installation
To install, follow the removal steps in the reverse order.
Sunshade
Disassembled View
665RS007
![](/vehicle/goneen/quin/zou/rean.png)
SUN ROOF/CONVERTIBLE TOP
8I–5
Legend
(1) Sunshade
(2) Sunshade Stopper
(3) Decoration Cover
(4) Sun Roof Deflector
Removal
1. Remove the decoration cover.
2. Open the sun roof half position, remove the sunshade
stopper screw and pull out the sunshade(6) until its
front side protrudes a little from the sun roof glass(2)
to remove the sunshade stopper.
3. Remove the sun roof deflector.
D
Refer to the Sun Roof Deflector in this section.
4. Open the sun roof completely.
5. Remove the sunshade guide rail stopper(5), and pull
out the sunshade up to the rail edge.
6. Remove the guide pin(4) in the sunshade through the
notch(7) of guide rail(1) and then draw the sunshade
out of the roof by pushing inward the retaining clips(3)
on both sides.
665RS008
Installation
To install, follow the removal steps in the reverse order.
![](/vehicle/goneen/quin/zou/ysonda.png)
8I–6
SUN ROOF/CONVERTIBLE TOP
Sun Roof Frame Complete Assembly
Sun Roof Frame Complete Assembly and Associated Parts
665RS009
Legend
(1) Sun Roof Drain Hose
(2) Sun Roof Frame Complete Assembly
(3) Headlining
(4) Sun Roof Drain Hose
Removal
1. Disconnect the battery ground cable.
2. Remove the headlining.
D
Refer to the Headlining removal steps in Body
Structure section.
3. Disconnect the sun roof drain hose at the sun roof
frame side as shown in the figure.
665RS010
4. Disconnect the sun roof harness connection.
![](/vehicle/goneen/quin/zou/myso.png)
SUN ROOF/CONVERTIBLE TOP
8I–7
5. Remove two sun roof frame complete assembly fixing
nuts (front side) and four fixing bolts (each side) from
the frame complete, and then remove the sun roof
frame complete assembly.
NOTE: Be sure to remove the frame complete while
supporting it.
Installation
1. Tighten the sun roof frame complete assembly fixing
bolts and nuts to the specified torque.
Torque: 10 N·m(1.0 kg·m/87 lb in)
2. After installing the frame complete, loosen the sun
roof glass fixing nuts and adjust the sun roof glass
setting position.
D
Refer to the Sun Roof Glass installation steps in this
section.
3. Install the sun roof drain hose.
4. Install the headlining.
Disassembled View
665RW033
Legend
(1) Sunshade
(2) Sun Roof Glass
(3) Sun Roof Motor
(4) Sun Roof Drive Unit Assembly
(5) Outer Tube Fixing Screw
(6) Sun Roof Frame Assembly
(7) Sun Roof Deflector
Disassembly
1. Open the sun roof.
2. Remove the sun roof deflector fixing screws and then
remove the sun roof deflector.
3. Remove the sunshade.
D
Refer to the Sunshade in this section.
4. Close the sun roof, remove the decoration cover and
the fixing screws and then remove the sun roof glass.
5. If the shims are used between the sun roof set plate
and the glass, note the number of the shims.
6. Disconnect the sun roof motor connector, remove the
sun roof fixing nuts and screws, and then remove the
sun roof motor.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст