Opel Frontera UBS. Service manual — part 2
![](/vehicle/goneen/quin/zou/maine.png)
GENERAL INFORMATION 0A–5
7. In this manual, the following action symbols
are used to indicate the type of service
operations to be performed.
. . .
Remove or disconnect
. . .
Adjust
. . .
Install or connect
. . .
Clean
. . .
Disassemble
. . .
Pay close attention - Important
. . .
Reassemble
. . .
Tighten to specified torque
. . .
Align the marks
. . .
Use special tool(s)
. . .
Correct direction
. . .
Lubricate with oil
. . .
Inspect
. . .
Lubricate with grease
. . .
Take measurement
. . .
Use liquid gasket
8. The service standard is indicated in terms of
“Standard” and “Limit”.
The “Standard” means the assembly standard
and standard range within which the parts are
considered serviceable.
“Limit” indicates the limit value (Correction or
replacement is necessary when measurement
is beyond this limit.)
![](/vehicle/goneen/quin/zou/hiseloronirs.png)
VEHICLE IDENTIFICATION NUMBER (VIN)
This is the legal identification of the vehicle.
It appears on the manufacturer’s Plate attached to the left
of the engine compartment front end. VIN number is also
stamped on the rear right side of the frame.
VIN
VIN
ISUZU MOTORS LTD.
JAC
UBS
26
G
Y
7
200001
Sequential Number
Plant Code
Model Year (Y: 2000)
Wheel Base (D: Short, G: Long)
Engine Type (26: 6VE1, 73: 4JX1)
Vehicle Model
World Manufacturer Identifier
ENGINE SERIAL NUMBER
The engine serial number is stamped on the left rear lower
area of the cylinder block above the starter.
4JX1
6VE1
0A–6 GENERAL INFORMATION
IDENTIFICATION
905RW014
905RW016
![](/vehicle/goneen/quin/zou/cmeshami.png)
GENERAL INFORMATION 0A–7
TRANSMISSION SERIAL NUMBER
Manual: Stamped on the left side of the transmission
intermediate plate.
Automatic: Stamped on the identification plate, located on
the left side of the transmission above the
mode switch.
96
0000 000
018
PART No.
SERIAL No.
SAL
HYDRAMATIC
STRASBOURG
MADE IN FRANCE
G 20
272
FP
SERVICE PARTS IDENTIFICATION PLATE
The Vehicle Information Plate (Service Parts ID plate) is
provided on all vehicle models.
It is located on the center dash wall inside the engine
compartment. The plate lists the VIN (Vehicle Identification
Number), paint information and all production options and
special equipment on the vehicle when it was shipped
from the factory.
Service parts ID plate
ISUZU MOTORS L T D. JAPAN
V.I.N.
M.D.
ENGINE
GRADE
TRANS.
TIRE
BODY TYPE
B. COLOR/TRIM
OPTION
905RW015
905RW018
905RW007
![](/vehicle/goneen/quin/zou/fthelag.png)
0A–8 GENERAL INFORMATION
LIFTING INSTRUCTIONS
CAUTION:
•
If a lifting device other than the original jack
is used, it is most important that the device
be applied only to the correct lifting points.
Raising the vehicle from any other point
may result in serious damage.
•
When jacking or lifting a vehicle at the
frame side rail or other prescribed lift
points, be certain that lift pads do not
contact the catalytic converter, brake
pipes or cables, or fuel lines. Such contact
may result in damage or unsatisfactory
vehicle performance.
LIFTING POINTS AND SUPPORTABLE POINT LOCATIONS
Long wheel Base Model
Short Wheel Base Model
Lifting point
Supportable point
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст