Opel Frontera UBS. Service manual — part 2239
6D3–13
STARTING AND CHARGING SYSTEM
Measure inner diameter of bushing in the rear cover, and
replace if it exceeds the limit.
Standard: 12.50 mm to 12.527 mm (0.492 in to
0.4932 in)
Limit: 12.60 mm (0.4961 in)
065RS028
Measure inner diameter of bushing in the center bracket
(P), and replace if it exceeds the limit.
Standard: 18.01 mm to 18.127 mm (0.7091 in to
0.7137 in)
Limit: 18.15 mm (0.7146 in)
065RS029
Reassembly
To install, follow the removal steps in the reverse order,
noting the following points:
Grease application places
D
Bushing in rear cover and center bracket
D
Gears in reduction gear
D
Shift lever operating portion
D
Sliding portion of pinion
D
Plunger sliding portion of magnetic switch
Reassembling Yoke Assembly
Before reassembly, make sure that no metallic parts
attach to the yoke assembly. Because of strong magnetic
force, hold the yoke assembly and insert it slowly into the
armature.
Torque
Torque for each part (See Torque Specifications in
this section)
Pinion Jump–out Dimension
Connect the “+” cable of battery to terminal S and the “–”
cable to terminal M. Turn the switch on, and measure
pinion travel dimension in thrust direction from the
jump–out position.
In measuring the dimension, pull the pinion out a little in
the arrow direction.
Dimension(L): 0.05 mm to 1.5 mm (0.002 in to
0.06 in)
065RS030
6D3–14 STARTING AND CHARGING SYSTEM
If the measured value is out of standard, insert dust cover,
or disassemble and adjust.
065RW019
Characteristic Test
For easily confirming the characteristics, conduct the no
load test as follows:
Rating as short as 30 seconds requires rapid testing.
Fix the starter on the test bench, and wire as shown in
illustration. When the switch is closed, the current flows
and the starter runs under no load. At this time, measure
current, voltage and speed to check if they satisfy the
standard.
065RW020
Legend
(1) Volt Meter
(2) Tachometer
(3) Battery
(4) Ammeter
(5) Switch
6D3–15
STARTING AND CHARGING SYSTEM
Main Data and Specifications
General Specifications
Model
HITACHI GD003138
Rating
Voltage
12 V
Output
1.4 Kw
Time
30 sec
Number of teeth of pinion
9
Rotating direction(as viewed from pinion)
Clockwise
Weight(approx.)
3.5 kg (7.6 lb)
No load characteristics
Voltage /Current
11V/90A or less
Speed
2700rpm or more
Load characteristics
Voltage/current
8.4V/250A
Torque
7.3 N·m(0.7 kg·m/64 lb·in.) or more
Speed
1200rpm or more
Locking characteristics
Voltage/current
3V/750A or less
Torque
19 N·m(1.9 kg·m/14 lb ft) or more
6D3–16 STARTING AND CHARGING SYSTEM
Torque Specifications
N·m (kg·m/lb ft)
E06RW044
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст