Isuzu Rodeo UE. Service manual — part 93
TRANSFER CASE
4D–35
25. Install ball bearing (17), using a bench press.
26. Select a snap ring (16) that will allow the minimum
axial play.
Clearance : 0–0.1 mm (0–0.004 in)
Snap ring availability:
Snap ring thickness
Color coding
1.55 mm (0.061 in)
White
1.60 mm (0.063 in)
Yellow
1.65 mm (0.065 in)
Blue
1.70 mm (0.067 in)
Pink
1.75 mm (0.069 in)
Green
1.80 mm (0.071 in)
Brown
1.85 mm (0.073 in)
Red
1.90 mm (0.075 in)
Orange
262RS015
226RS021
27. Use a pair of snap ring pliers to install the snap ring
(16) to the output shaft (31).
Sub-gear (anti-lash plate) preload
1. Hook a length of piano wire (52) over one of the
sub–gear (53) teeth.
2. Attach the other end of the piano wire to (52) a
spring balancer.
3. Measure the sub–gear preload.
Preload: 59–98 N (13–22 lb)
226RW156
28. Install front output gear assembly (15) to transfer
case (42).
29. Use a pair of snap ring pliers to install the snap ring
(14) to the transfer case (42).
NOTE: The snap ring must be fully inserted into the
transfer case snap ring groove.
30. Use a bench press to install the ball bearing (12) to the
input shaft (13). (A/T)
265RS003
4D–36
TRANSFER CASE
31. Install plate (11), ball (10) and bearing collar (9).
32. Install needle bearing (8) and input gear (7).
33. The clutch hub face (with the heavy boss) must be
facing the transfer input gear side (55).
226RW158
34. Install high–low clutch hub and sleeve (6), using a
bench press.
35. Install input shaft assembly (5) to transfer case (42).
(A/T)
36. Install the snap ring (4) to the transfer case (42). (A/T)
NOTE: The snap ring must be fully inserted into the
transfer case snap ring groove.
37. Install the front companion flange temporarily and use
the flange holder J–8614–11 and lock nut wrench
J–37219 to install the lock nut (3).
Torque: 137 N·m (101 lb ft)
226RW137
38. Use the punch to stake the lock nut (3) at one spot.
39. Use a suitable drift and hammer to install the ball
bearing (2).
226RS079
40. Install bearing snap ring (1).
TRANSFER CASE
4D–37
Main Data and Specifications
General Specifications
Type
Synchronized type gears shifting between the 2 and 4 wheel drive mode.
Constant mesh type gears shifting between “low” and “high”.
Control method
Remote (A/T) and direct (M/T) control with the gear shift lever on the floor
for gears shifting between “low” and “high”.
Electric control with the button switch on the instrument panel for gears
shifting between the 2 and 4 wheel driver mode.
Gear ratio
High; 1.000
Low; 2.050
Oil capacity
1.45 lit. (1.53 U.S. quart)
Type of lubricant
Engine oil
Refer to chart in Section 0
Torque Specifications
E07RW022
4D–38
TRANSFER CASE
E07RX006
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст